Electronics Forum | Mon Dec 20 12:42:15 EST 1999 | Charlie
There is a need to set up the spray fluxer on our wave machine. I'm looking for guidelines and comments form others who have done this set up. Also, is there any rule of thumb at visual inspection when there is too much or not enough flux being appli
Electronics Forum | Thu Feb 14 04:40:38 EST 2008 | lococost
You want the backplate set up so that when there's no PCB the wave stands still or moves towards the PCB. When the PCB moves over the wave, it should just pull the wave towards the back (in the same direction as the PCB). This will help reduce brid
Electronics Forum | Thu Dec 23 22:31:47 EST 1999 | Vincent Chen
Hi!Charlie, 1.Are you retrofitting your spray fluxer in your wave soldering machine? If you are, please ensure that you have a air knife just before the preheater!Fluxe fumes tends to accumulate and that could be dangerous if your air exhaust is not
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg
Electronics Forum | Fri Jun 15 12:07:13 EDT 2018 | fern
My company is hooking up a delta max wave solder machine but we can seem to get the estop error to go away any one have a any experience with this issue.
Electronics Forum | Mon May 07 10:27:40 EDT 2007 | colormaker
The spray bottle puts more flux on the board but I am not sure how to measure ? I just got the Novastar 12S and its very difficult to set up. When I fix one problem another one show up. When I do get good results I dont make changes and then after a
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Tue May 04 14:42:58 EDT 1999 | Chrys Shea
| | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I wi
Electronics Forum | Mon May 10 07:53:48 EDT 1999 | Timothy O'Neill
| | | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I
Electronics Forum | Mon May 10 08:00:14 EDT 1999 | Timothy O'Neill
| | | | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so