Electronics Forum | Wed Jan 18 12:57:22 EST 2006 | cyber_wolf
Since I have posted on this last, we have found that 99% of our nozzle sticking problems are do to part height problems. I have been told that CP6 machines are very sensitive to part height do to the amount of spring travel in the nozzle. If you hav
Electronics Forum | Thu Feb 24 06:11:18 EST 2005 | siverts
Nozzle used? Nozzle tip damaged/worn-out (that's where the nozzle life comes in)? Component package? Heavy component? Feeder? Do You see that component type, used by that nozzle inside the machine, or components at the wrong spot on the pcb? If so, t
Electronics Forum | Sun Mar 06 17:10:41 EST 2005 | Darby
The manual gives you a fair idea here. Reference for the Yamaha manual is THE6006 - I don't know if Philips is the same. Cause is either overload or overcurrent. The manual suggests that you can tweak the trimmers on the driver board but these are us
Electronics Forum | Tue Mar 15 18:42:57 EST 2005 | simmcircuits
Hi, Can anyone give me a bit of an advise or tip on how to reduce the flux residues on the board when it comes out of the wavesolder machine. The Vitronics Soltec 6622CC that we are using have been producing boards like this for years and people her
Electronics Forum | Thu Mar 24 17:36:31 EST 2005 | Grant
Hi, Yes MYDATA vibration feeders are a nightmare, but you might want to check the feeder. We had one that would vary a lot, and it never seemed to be able to be set to the right vibration level for consistent feeding. It turned out to have a problem
Electronics Forum | Fri Apr 22 14:28:38 EDT 2005 | Gary Goldberg - PROMATION
Low end selective laser soldering systems are limited to what types of soldering can be performed. I have read through the previous comments and find that most have commented on earlier technologies (which do not offer the features today's system do)
Electronics Forum | Wed Apr 27 11:43:32 EDT 2005 | patrickbruneel
Hi Daan, What we did in the time was pareto analyses on all board designs to determine the critical areas (mainly design errors) and only inspect those specific problem areas. Every batch had a copy of the PC board with problem areas marked and only
Electronics Forum | Wed May 18 14:58:05 EDT 2005 | splice
Hi, I am having some PTH non wetting issues. Setup and chronology of events is explained: Set Up; Part: 1 MM pitch connector 378 pins Solder: Kester Ultra Pure 63/37 solder Pot; 250 C pre heat; Peak 94C top side Flux: Qualitek 775, Fluxer: foam T
Electronics Forum | Thu May 26 12:21:04 EDT 2005 | stepheniii
We have dek-my12-my12-heller. We are very happy with it. Change-over time varies more by facility than by machine type. I worked at a place with dek-mviif-msf-btu and we had faster changeovers there. There we had a dedicated feeder set-up. Close to
Electronics Forum | Wed Jun 22 06:18:07 EDT 2005 | dougs
We started looking at tabletop AOI systems last year, one of the main criteria, as we are a SC was that the sales engineer programmed one of our boards in front of us so we could see just how easy to program it was, also high on the list was performa
.png)
