Electronics Forum | Wed Mar 04 08:32:45 EST 2020 | stephendo
We bought a conformal coating removal machine AKA a sand blaster at an auction. It is a CCR2000 especially made to be ESD safe. Does anyone have any experience with sandblasting conformal coating? We mostly use humiseal 1A33 and UV40. When we use the
Electronics Forum | Sun Nov 04 01:11:19 EST 2007 | daxman
If we're comparing a TP9 or a MY9 to anything FUJI, I think the IP3 has it beat by a long shot. You can get a used IP3 with an MTU for under 35k. The only downside is that you require a programming interface with Fuji and it's built into the MyData.
Electronics Forum | Fri Jun 04 11:54:22 EDT 2021 | cbart
We do this quote often with our older Summit machine. there are a few ways to do this. all of these are assuming you have parts on the boards already and are working around them. 1- if you have a good tech that can add solder to the pads on the PCB a
Electronics Forum | Mon Jul 27 13:26:00 EDT 2020 | lpbro
Get a gimbal for your phone to steady the shot. The video will look much more professional.
Electronics Forum | Sat Sep 21 20:27:48 EDT 2013 | hello123
Thanks for the help. I'll give it a shot.
Electronics Forum | Mon Mar 09 16:28:48 EDT 2020 | sportsradar
Hello Sarason, Unfortunately the machine is no longer supported and we are such a small company we can not afford to replace this machine. Thank you for your advise, I will check for additional parts stuck in the machine (long shot but worth the time
Electronics Forum | Wed Sep 07 16:31:26 EDT 2016 | mnorthey
You can inspect joints using an X-ray machine and we use a sand-blaster type machine which blasts (Starch) to remove the conformal coating. (Carbo Blast). However; the inspection should be done prior to Coating, as we all know some jobs are rushed t
Electronics Forum | Fri Feb 22 08:13:02 EST 2008 | davef
Try: * Grainger [www.grainger.com] * Mc Master-Carr [www.mcmaster.com] Use a blast gate like McMaster-Carr 1822K315 located on each port of the machine. These will help balance the air flow entrance to exit as well.
Electronics Forum | Fri Dec 13 19:01:14 EST 2002 | Tooling Guy
I have heard of people using tiny lead-shot filled bags to hold down thru-hole components on circuit boards while running through a wave solder machine on selective solder pallets. How successful has this been? What kind of material is being used f
Electronics Forum | Fri Aug 07 15:56:56 EDT 2009 | davef
Well, since you've gotten no takers, we'll launch in to this with careful analysis and introspection, fully aware that we're likely to get 'blasted' for any number of reasons. The most critical parameters to monitor for proper wave solder machine pr