Electronics Forum | Mon Apr 26 16:02:30 EDT 2010 | markhoch
Are the drive motors DC? Reverse polarity on the motors and switch your photosensors on the entry and exit end. You might have to play with the SMEMA connections a bit, but you'll figg it out. ;)
Electronics Forum | Fri Jun 27 11:56:37 EDT 2014 | sumote
Colleagues, I have a JT-620L Wavesolder machine (Made by JYI DIANN MACHINE) that experienced a power fluctuation and had the factory programming wiped. If someone would be so kind to read the settings on the (4) VS-606V7 controllers I would be very
Electronics Forum | Tue Feb 06 04:54:39 EST 2018 | Robl
Smells a lot worse even with good extraction. Key things to look out for is laser life on your thickness and layup of panels compared to spindle motor life (Typically 10,000 hours, or 2 years for us) and cost of replacement lasers. We get spindle
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Sun Mar 07 09:24:55 EST 1999 | Scott Cook
| Hi Ya'll... | it's a Soltec Prisma and the conveyer keeps jamming. What it's doing is up at the exit end where the drive motor is, the chain keeps wrapping itself around the drive sprocket and jamming...this is on the backside rail, the frontside
| 1 |
