Electronics Forum | Thu Apr 27 08:42:22 EDT 2017 | pvasquez
Hello M. We are a low volume high mix manufacturer with a total of 7 Mirtec AOI machines including a new MV-6 OMNI 3D system. I am very pleased with this machine! When we did our 3D AOI research, my team narrowed the field down to 2 vendors, Mirt
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Mon Oct 15 21:16:57 EDT 2018 | comatose
Be careful about used AOIs, some of the companies have truly outrageous registration fees (ten, fifteen grand) without which you can't get support or parts. 2d AOI is of pretty limited utility other than detecting a wrongly mounted reel during plac
Electronics Forum | Tue Aug 10 16:55:19 EDT 2004 | mriddle
RS, It seems you've been doing your homework. However, the real question is what do you need to do with AOI? 1) What is your minimum cycle time? This would help you to determine the speed you need and whether "scan on the fly" is warranted. Also,
Electronics Forum | Thu Jan 04 20:31:21 EST 2007 | Ben_T
Have you thought about an AOI system? With the system we have where I work, I'm able to run queries that'll tell me DPMO, yield, and pass/fail rates on a board level, part level, and opportunity level. Furthermore, this data can be broken down to see
Electronics Forum | Fri Oct 17 14:26:39 EDT 2008 | hegemon
We use Mirtec MV-7s for post SMT inspection of solder joints as well. The artistry is in the program debug. We are very pleased with the solder inspections provided by these machines, and technology having advanced bit, most every AOI machine has t
Electronics Forum | Wed Jun 14 16:27:13 EDT 2006 | vikkaraja
Talk to Fuji regarding this issue, there is retrofit kit for the mark read camera amp.( it's black color box on top of the machine from side one on your right hand side). And also check you software there might be upgrade available from fuji. I hope
Electronics Forum | Wed Aug 07 14:51:31 EDT 2019 | alexeyzb
Hello! I used three SpeedPrint 210avi in our factory. They worked ok, but i had some problems: 1) Printer foil clamps. Steel thin blade which press PCB on table is connected to metal base by glue. As a result you need to change it every month, but af
Electronics Forum | Sun Nov 27 11:19:55 EST 2005 | cyber_wolf
Dude, Scope the big ribbon cables on either side of the X-axis for cracks. They usually break where the clamp holds them on the X wagon. Also, all of your X camera stuff goes through the XWB board.Try swapping it if you have another. I am not sure
Electronics Forum | Fri Apr 21 13:28:51 EDT 2006 | cyber_wolf
Chunks, I know about the board stopper in the camera. I forgot to mention that our 1 AP25 is a HI-E machine with that camera in it. The HI-E still uses the dedicated tooling. When the snuggers engage the board pops over the mechanical stop. We do