Electronics Forum | Mon Nov 04 14:56:35 EST 2019 | stephendo
I think it might be the best choice for OEMs that only run one finish and practice JIT. (taking cost into account) For everyone else I think they will eventually run into trying to use them too long after they have been opened. But when you can run b
Electronics Forum | Thu Dec 19 10:53:15 EST 2019 | kithnelso
Can any one tell me what I would need to replace this yellow disc. I have another board that this part has burned up, and I need to find a replacement. The manufacturer is Buss, however I cannot find any information with the numbers printed on it. Th
Electronics Forum | Tue Feb 04 14:03:13 EST 2020 | dekhead
As long as pressure is set properly (may require re-adjustment when adding / removing modules) then have not seen / heard of issues with damage to bottom side components. This assuming that rubber tips are in place and in good shape. I have a custome
Electronics Forum | Fri Jan 17 09:34:22 EST 2020 | emeto
It looks like you have a simple version of the Horizon. You should have a scale on the right side with a stopper. When you create a new program you will define where the stopper should be. I used to same this value in the program description field, s
Electronics Forum | Tue Feb 11 04:08:51 EST 2020 | majdi4
we have a problem : The connector is falling down in the second reflow. This connector is mounted in the first side. You can find attached the reflow profil we work with and a photo of the connector. We tryed with under_film but the connector is sti
Electronics Forum | Fri Feb 21 07:14:59 EST 2020 | bk
I would always have top and bottom preheaters in a solderwave machine. Even if you can make it work without them, it's better to heat both sides of a board then just one. Far less stress on the parts you are soldering. Plus you may need it one day fo
Electronics Forum | Fri Mar 06 14:33:53 EST 2020 | bk
Another thing you can check is where the bar comes down off of the hydra z motor there is a little bearing you can see from the front make sure that bearing is turning even oil it up a little. You can also adjust the tension by loosening the tiny set
Electronics Forum | Mon Feb 24 17:06:36 EST 2020 | emeto
It looks like one oven is 10years newer than the other, so if we assume same maintenance routine you should get another 10 years if life on it. On the TH side, you know your board complexity - for me wave have much more value than a Selective. Selec
Electronics Forum | Tue Mar 03 07:47:48 EST 2020 | dontfeedphils
Thanks for the info. In a past life I ran everything WS and washed in a batch wash using saponifier. I'm surprised I never saw anything then as we would regularly wash boards assembled on only one side. Unless it's specifically washing in DI only.
Electronics Forum | Thu Feb 27 15:14:53 EST 2020 | SMTA-Alex
This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an A
