Electronics Forum | Mon Aug 12 12:05:35 EDT 2002 | russ
I use Paste for high temp balls and/or co-planarity/warpage issues. normally I only use paste flux for ball attachment. One down side to paste application is registration and volume anomalies with those little micro-stencils (for me anyway). Your
Electronics Forum | Tue Sep 03 22:32:04 EDT 2002 | davef
Naw, alcohol and solvents won't do dip. Hold-off on: * Destructive testing. [Athough this will convince you to move on to other things.] * Rework of the solder connections. [Although this will correct the problem.] Consider investigating your aque
Electronics Forum | Sat Sep 14 01:34:19 EDT 2002 | Yngwie
I have the following questions on Via in Pad and want to understand each of them wrt : - complete Via in pad - partial encroachment - via partially in pad 1) What is the general feel for via in pad for upcoming designs? 2) What are the manufacturi
Electronics Forum | Tue Sep 17 00:40:39 EDT 2002 | yngwie
Hi all Experts, Desperately need your help on the following questions on Via in Pad and want to understand each of them wrt : - complete Via in pad - partial encroachment - via partially in pad 1) What is the general feel for via in pad for upcom
Electronics Forum | Wed Sep 18 10:06:30 EDT 2002 | Bob M
I place 15-20 mil a lot. You need to look at your pad to apature reduction. Your stencil thickness. The type of paste your using. We use 2-5 mil reduction on each side as a general rule on fine pitch. This varies depending on pad width. We also use 5
Electronics Forum | Wed Sep 18 16:56:55 EDT 2002 | stockley
I started writing a long winded explanation about SMEMA and realised that it is just as easy to write about this as it is to talk about it on the phone. It just so happens that I have recently gone through this process so I believe that your vendor
Electronics Forum | Tue Sep 24 07:32:58 EDT 2002 | cyber_wolf
Pete: It is a Panasonic Camera. MPM tells me that they no longer sell parts for that vision system, and in order to fix this problem I have to do a vision up-grade. The upgrade is over 20K if I remember correctly. That is not going to happen. I hav
Electronics Forum | Fri Sep 27 17:42:35 EDT 2002 | russ
i don't know of any "handy dandy" but something I use is tape width minus 4mm for the max component size that can be fit into tape widths of up to 32mm. 32mm and larger have holes on both sides which would then be tape width minus 7mm. I have never
Electronics Forum | Fri Oct 11 12:19:11 EDT 2002 | Randy V
All information regardless of its origin should be questioned and not taken without some data. I have been working in Electronics for allot of years and I have worked with some very competent reps and some real bad ones. Reps usually refer me to the
Electronics Forum | Fri Oct 18 16:24:05 EDT 2002 | russ
Big BIG BIGG wave with a lot of preheat capability both top and bottom. You may need to exceed the standard "100 C" top side preheat to 120C or so (be aware of any topside SMT going into reflow over the wave). A spray fluxer with very fine atomizati
