Electronics Forum | Mon Dec 11 14:09:58 EST 2017 | deanm
Some pick and place machine manufacturers offer dual lane feeders which may double the machine's feeder capacity. What are the pros/cons of using dual lane feeders in a high mix environment? Are they just for 8mm? Thanks!
Electronics Forum | Mon Dec 11 19:28:51 EST 2017 | spoiltforchoice
That's not really the point of dual lane feeders. As a general rule having a dual lane 8mm feeder means the machines "slots" are actually 16mm, dual lanes on a 8mm feeder helps keep the overall lane density of a machine higher, its much easier to bui
Electronics Forum | Tue Dec 12 12:03:39 EST 2017 | dleeper
A lot of it depends on what machines you are using and how well they implement dual lane feeders. A few general comparisons: Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders Cons: -two
Electronics Forum | Wed Dec 13 01:14:02 EST 2017 | tsvetan
"Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders" none of these is true for Sony SI-G200 machines we have dual lane feeders are bigger than the standard 8 mm feeders so no space savin
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Wed Jan 18 13:45:07 EST 2006 | PWH
Advantis 8mm feeders - I intend to buy all prec. pro. feeders intitially. Is it advisable to buy all dual lane 8mm or do I need single lane 8mm mixed in as well for any reason?
Electronics Forum | Wed Jan 18 14:48:40 EST 2006 | PWH
Dual lane 8mm prec. pro feeders are capable of being set for 2mm or 4mm index, correct?
Electronics Forum | Mon Jul 25 03:39:25 EDT 2016 | rob
A 200% + increase in load time certainly erases > any thoughts of efficiency in my mind. We have tried the Visker Electric feeders out (Yamaha & Juki)and they are nice and smooth, with a faster recovery rate, also adjustable pitch. However, with
Electronics Forum | Sun Oct 10 00:47:01 EDT 2004 | Grant
Hi, I checked one out in Taiwan recently, and they had two NXT systems on the booth. I think they are very exciting, and being able to change the mounter head and camera, and dual lane is good for through put. However each bay is only 20 x 8mm feed
| 1 |
winsouce.jpg)