Electronics Forum | Fri Aug 27 14:44:24 EDT 2010 | namruht
Ok...Maybe there isn't such a place. I am suppossing that everyone purchases from the machine manufacturer. Does anyone know of a third party unit that work well? I would like to be able to get a unit that we allow us to calibrate our siemens and uni
Electronics Forum | Thu Oct 07 16:55:19 EDT 2010 | cbroegger
Hi, This one should be for the TSSOP16 and up to TSSOP20 : 00343788-02, check the attached pdf.
Electronics Forum | Tue Jul 07 13:26:37 EDT 2020 | emeto
Yest you can. You need the calibration station, that you can buy or loan from ASM.
Electronics Forum | Tue Feb 14 17:52:58 EST 2023 | mnorthey
We have 3 S20's and an F4 and about 150 Hover Davis Feeders. Is there anything you might need to keep your machines operational? We are looking to sell all of the machines.
Electronics Forum | Tue May 06 10:14:18 EDT 2003 | k_h
A typical machine will have around 100 feeder slots. Manufacturers use the slots differently though, use 8mm feeder counts as your basis. Siemens, for example has 40 slots but you can get 2 (or 3) 8mm's per slot giving you 80+ 8mm feeders, while a Sa
Electronics Forum | Fri May 09 10:29:23 EDT 2003 | k_h
72 different part numbers, 53 being 8mm, remainder being 12-44mm and 3 tray. It may be low but anymore than 100 and you give up throughput because of feeder locations. And thinking about it, 70-90 is low for a low volume high mix line. I guess if I w
Electronics Forum | Mon Mar 20 22:33:08 EST 2000 | RJJOHNSON
Cim system is what we used on cp6 d axis tables.It worked very well.I liked it and it was for pre run and during run feeder feeding.Uses a barcode reader and reads bottom of d axis where barcode are to match what is assigned to a slot by pre scanning
Electronics Forum | Mon Mar 20 22:33:08 EST 2000 | RJJOHNSON
Cim system is what we used on cp6 d axis tables.It worked very well.I liked it and it was for pre run and during run feeder feeding.Uses a barcode reader and reads bottom of d axis where barcode are to match what is assigned to a slot by pre scanning
Electronics Forum | Wed Dec 05 10:16:42 EST 2001 | vervin
G. I utilized the line computer setup print outs and transferred this information to a controlled document. Our operators are only responsible for operating the machines not programming. In our W.O.I.'s, I list the .la file, the setup. I list each
Electronics Forum | Tue Apr 11 15:23:43 EDT 2006 | Cal
Hi Shawn- If I can remeber....from my Siemens Days on the S15 or F Series Once you send the program over to the machine from the line computer...You can not skip. Remember, these machines in theory are not ment to stop running (i.e. Thus the feeder s