Electronics Forum | Fri Sep 24 22:43:07 EDT 2004 | FengAng
Hi Rob, We use the most advanced equipments in front end, but the back end we always use manual assembly, including display, LCD, casing. It's all because we should balance the cost & efficiency. I think if you are the boss, you will also do thing
Electronics Forum | Tue Aug 25 16:46:48 EDT 1998 | Bill West
| | | I am considering of Philips FCM for the next production. Jim, I think I would take the Phillips machine over the Fuji also, but have you looked at the Siemens F4 or F4/6. We are a Siplace house here, and we have been very happy with the equip
Electronics Forum | Fri May 31 16:16:42 EDT 2002 | Ozzy
Does Fuji even make the QP-132 anymore? I have not seen it at Apex for the past 2-3 years. This "inflexible" dinosaur was a commercial disaster for Fuji. Philips/Assembleon has sold countless more FCM than Fuji QP-132. The problem with both machines
Electronics Forum | Wed Dec 06 23:12:09 EST 2000 | Brad
Chris, Have you considered Fuji? The robustness of Fuji is proven. I have recently done floor space analysis and cost per placement/sqr foot studies. I have also performed ROI studies on these machines. The new CP7 machine from Fuji outperforms th
Electronics Forum | Fri Jul 09 16:43:18 EDT 2004 | Sam
If pure speed is the main requirement then I would still not go with Turrent technolgy machines. The FCM from Assembleon (Now AX) is the fastest machine in the industry and consumes much less floor space then any Turret. Gantry machines such as Siem
Electronics Forum | Fri Sep 24 05:34:12 EDT 2004 | FengAng
Hi Rob, I don't think you're so right about this thing. In China, there're so many companies that are using the most advanced equipments in the world. Machines using in Europe can also be found in China. In my company, we have the equipments like S
Electronics Forum | Sun Jul 10 13:24:48 EDT 2011 | sarason
I have finally updated my shareware SMT Machine program It reads Protel ( from Autotrax to Altium Designer) and spits out Yamaha/Philips UFOS, VIOS , Mydata, Fuji MCS2 CP642 CP732, Gencad 1.3, Philips, FCM, ACM, FTIP, Essemtec, Panasonic BM221 CM88,
Electronics Forum | Tue Sep 21 11:22:20 EDT 2004 | rlackey
Hi Arvydas, Do you want a machine specified at 20K per hour or to run at 20K per hour? Regarding Chipshooters I've worked with Siemens, Philips FCM's, Fuji's, Panasonics & Sanyo/Universal and the best in terms of reliabilty by a long way were the J
Electronics Forum | Sat Oct 17 08:03:47 EDT 1998 | Stefan Witte
I think the Universal and the Siemens machine are a good marriage. However, dealing with two different vendors may create additional difficulties. As both parties want to make the deal with you, you might want to bypass the sales people to get more i
Electronics Forum | Fri Oct 16 08:47:58 EDT 1998 | Scott Cook
John, I'll throw my bit of confusion into the pot, here. Your limited floorspace, coupled with your technology mix vs. volume mix narrows the scope of your search. You don't say what your budget is, or whether you are looking for speed. I'll give y