Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co
Electronics Forum | Fri Jun 26 00:36:28 EDT 2020 | victorzubashev
Hello Lazlo, do you still have a problem with the machine? Victor
Electronics Forum | Thu Dec 03 17:56:59 EST 2020 | ravikumargv
Hi, Ip and mc host both pinging and no issues, but still sitest given communication error, for this i replaced communication card and lan cable as well. But machine software not booting at all... Regards, Ragav
Electronics Forum | Fri Aug 28 16:18:36 EDT 1998 | Bill West
I am looking to start regular communications between all users of Siplace. If you are interested, please E me at bwest@paramit.com. Please include: Name: Company Name: Complete Address: Phone: Fax: Siemens equipment: Bill West Manufacturing Engineeri
Electronics Forum | Mon Mar 06 13:00:37 EST 2006 | global
We have a Siplace S15 and I would like to know if it is possible to make it skip a part during the placement operation with out aborting the job? In section 5.4.4.4 of the user's manual it describes how to set a track to empty and proceed on with the
Electronics Forum | Sun Dec 05 17:13:32 EST 2021 | oxygensmd
There is a small round (endless) spring inside segment. I think it felt off or damaged. Replace it.
Electronics Forum | Tue Nov 30 19:57:54 EST 2021 | erici
May i know how you did the MC-distribution to the MC. I am having same problems with our machine now. Thanks
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
.gif)
