Electronics Forum | Tue Mar 29 13:14:28 EST 2005 | bobpan
Anyone familiar with making smema work on the ekra x5. I believe is was manufactured with a siemens (not smema)setup. We found the cables to make the siemens work but i am not sure if i can short a couple of inputs on the cable to make the smema func
Electronics Forum | Fri Apr 01 07:38:52 EST 2005 | bobpan
The machine has 2 25 pin cables that are supplied with it and you have to have adapters that plug into them for smema or siemens. The cables are x20 and x21 smema pigtails.
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Thu Dec 04 15:06:28 EST 2008 | kmakiya
PFC box is upstream and Agilent is downstream. If Agilent conveyor runs with no board upstream pins 3 & 4 made be shorted. This should not be the case if there is no board upstream.
Electronics Forum | Mon Oct 16 16:05:59 EDT 2000 | CAL
Brian- IPC has SMEMA Down loads for communication protocal: http://www.ipc.org/html/fsresources.htm. Also, I interfaced a fuji CP6 with a Siemens s20 and had to put in a relay and sensor to complete the communications loop. Fuji uses a 24v on/off com
Electronics Forum | Tue Nov 03 22:11:38 EST 1998 | phillip hunter
| SMTnetters: | | My UIC conveyors aren't working with my: | | �Omniflow 7 Reflow (Mfg 1/95) | �Dek 265 GS | �Philips CSM | | | What can I do? Does anyone have experience with connecting UIC or other conveyors to the above equipment? On the refl
Electronics Forum | Sat Jan 17 07:25:18 EST 2004 | Andreas
I need to connect a Universal HSP (SMPI, Upstream) with a SMEMA interfact (downstream). Can anyone give me some information about the SMPI interface? Or does anyone have a schematic of a conversion box from SMPI to SMEMA? Thank you! B.R. Andreas
Electronics Forum | Mon Jan 08 10:39:23 EST 2007 | bobruz
Hi everyone! I need several Upstream & Downstream SMEMA Interface cables for the line I'm pulling together. Can anyone advise me on where to buy some pre-made cables or do I have to do them all myself? Thanx, bobruz rruszanowski@moog.com
Electronics Forum | Tue Jan 08 17:46:38 EST 2008 | swag
If the phone jacks have two conductors in them, I would wire them to standard SMEMA connectors so that the upstream side goes to the middle two SMEMA pins and downstream goes to the outermost two pins. If there are 4 conductors in the phone jacks, y
Electronics Forum | Fri Jul 22 18:22:36 EDT 2011 | garym4569
We have a inline YesTech YTV-2000 in a newly configured SMT line and having issues with the transfer system. Shortly after the unit is put in run mode, the conveyor will turn on and run as if it is attempting to load a pcb even though no pcb availab
.gif)
winsouce.jpg)