Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Fri Feb 05 12:25:37 EST 2010 | baildl632
Yes, it's powered up. We use a simple power supply that connects directly to the drive. It spins up fine. I belive my problem is with Windows not recognizing the old type of drive correctly. It does recognize it as a mass storage device (the drivers
Electronics Forum | Mon May 20 15:22:55 EDT 2013 | smtventasmex
Check the wire for the breake i change that and conector plug ont he breake is diferent and i have to change the wire, if you need more help contact me at vmaderoATsmtvys.com
Electronics Forum | Fri Apr 08 09:42:31 EDT 2022 | bukas
thanks for help guys. I changed HDD and mounted image from a working machine then I ran a calibration. It still moves paste left and right but distance is much smaller so prints are acceptable. I have a spare vision card will try it tomorrow. Do I ne
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Tue Mar 22 13:00:37 EDT 2022 | bukas
hi, I have a 265GSX machine that prints firs PCB in batch correctly and then missprints the rest(there may be acceptable prints by accident). after hitting END RUN and RUN again, first PCB comes out perfect but others are bad. paste is randomly shift
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
Electronics Forum | Mon Sep 02 23:56:08 EDT 2013 | dekhead
Looks like too many signals there for a DEK SMEMA board to handle; trying to translate / ascertain what signals those are, to offer possibilities to communicate with DEK; However would pretty much guarantee a need for hardware change (personality car
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Wed Aug 26 18:36:17 EDT 2020 | serge_pirog
Hello. Could I ask you for help. We have DEK Europa. We have changed ProFlow to squeegee head with feedback. After this during solder paste printing system shows the difference between set pressure (9 kg) and real pressure (7,5kg). I have read manual
