Electronics Forum | Wed Feb 20 10:26:56 EST 2013 | wbailey
I am getting a lot of false calls on our AOI(YTV F1)on low contrast part markings like brown-on-yellow tantalum capacitors and etched oscillators, and on lead banks where the pcb has the part outlined in silkscreen. We are contract and cannot change
Electronics Forum | Wed Feb 20 18:04:56 EST 2013 | hegemon
You should have a number of lighting options to deal with the low contrast lettering. Low angle, B/W, reverse color. etc... If I am reading you right, you might have your bridge inspector too far out on the lead banks, that it is seeing the silkscree
Electronics Forum | Fri Aug 02 14:16:02 EDT 2024 | proceng1
As we are CM, our part numbers are specific to our Customers. So the "images" of NotPop parts do not vary quite as much. I basically use a COLOR INSPECTOR and choose the soldermask inside the silkscreen, which would be blocked if a part were present
Electronics Forum | Thu Feb 28 10:22:46 EST 2013 | rway
If your silkscreen is too close to the toes of your leads, you can bring the lead bank inspection box in a little bit to compensate. I haven't had many issues with tantalum caps. I inspect those under white light with no filter just fine, but then
| 1 |
winsouce.jpg)
.gif)
