Electronics Forum | Sat Sep 20 07:11:28 EDT 2008 | Sean
Hello All, I used to hear that PCB with immersion silver finishing, its non component location pads, tend to be discolour (Yellowish) after went through heat cycle, such as reflow oven. However, if the component solderbility on the PCB is OK, can w
Electronics Forum | Mon Apr 01 07:41:40 EST 2002 | davef
Hey Bob, Boy, you are lucky to have a laboratory, and now colorful pix!!! The only silver IMC that you will see are: * Ag6Sn, much less likely at 'normal' soldering temperatures * Ag3Sn, much more likely Allowable silver concentration: * Below 2%
Electronics Forum | Tue Nov 21 12:35:59 EST 2006 | CK the Flip
It probably depends on the Silver content. We are also using Sn62Pb36Ag2. The paste manufacturer told us that the reason for the small silver content was so that it could wet better to the lead-free component and board finishes bearing silver.
Electronics Forum | Fri Aug 29 07:22:05 EDT 2008 | realchunks
Omid, Try changing your profile. I had the exact same thing happen to me in 2006. Eventually I had to change my paste. No lead parts can and DO have a different finish that Pb parts. Why do you think the rest of the world increased their oven te
Electronics Forum | Tue Mar 17 13:11:58 EST 1998 | ETS, LLC
ETS (Energy Technology Systems) is a manufacturer of Solder Reflow and Curing Ovens for the Electronics Industry. We offer a specially configured oven designed for processing of Pin in Paste processes as well as double sided mix technology boards. I
Electronics Forum | Wed Apr 16 16:55:38 EDT 2003 | russ
Thanks for the info, Here is a couple more questions (and you thought you were done) What size are these caps /res? how thick is your stencil? what type of oven are you using? what is the finish of the board? Anyway, it seems like (from a distance)t
Electronics Forum | Fri Nov 22 15:59:43 EST 2002 | GSW
What type of reflow profile are you using ? There is a void reduction profile recommeded by some paste manufacturers, Try that it might help. Did you check the components or the board and see if they have absorbed mositure ? try baking the boards and
Electronics Forum | Fri Mar 19 12:09:17 EST 2004 | Primus
I'm just getting more involved with SMT, as I've been a through-hole operator for years. But I don't understand how one could reflow SMT components AFTER the through-hole insertion and solder wave are finished. How does one print paste over a board w
Electronics Forum | Tue Jun 27 08:38:03 EDT 2006 | cuculi54986@yahoo.com
I tried some SN100C from AIM... On only one array. It flowed well on the chips but did not like the finish on the SOT23's on the board. I did not have enough arrays to mess around, so we switched it over to SAC305 and had no issues. I'm guessing w
Electronics Forum | Tue Mar 09 07:51:12 EST 2004 | Bryan
Hello everyone: 1.I use Kester R244 63/37 solder paste. 2.Stencil thickness 6 mil. 3.Springdale Chipset. 4.PCB finish:HASL 5.Profile:Peak temp.:210~220C,time above 183C:60~90 seconds,time between 150~183C 60~90 seconds. 6.Reflow oven:Heller 1800 Voi
