Electronics Forum | Tue Apr 13 07:48:00 EDT 2004 | Dougie
Hi Ken, Our product is consumer, although our product is sold on it's reliability. We run a low volume high mix throughput. Any ideas on timescale for the Ag leaching? Sounds like it could be a safer bet to use Imm Sn boards with the Sn/Cu/Ni bar w
Electronics Forum | Tue Apr 19 11:54:36 EDT 2005 | masters
The email address was stripped from this post, a user complained about receiving a virus or some malicious code from the suspected address. Knowingly sending viral code is against the law. Posting personal information to circumvent SMTNet is again
Electronics Forum | Thu Aug 31 02:10:42 EDT 2017 | hxamalia
Hello ALL Good day , it is Amalia from HX Circuit Technology Co.,Ltd in China, we are a prefessional PCB factory with many years. We are focusing on quick lead time for PCB with good service . please contact with me now ,thanks Email: amalia@hx-c
Electronics Forum | Wed Apr 07 09:23:20 EDT 2004 | davef
In addition to your concerns about leaching, why aren't you concerned about: * Tin whiskers * Total absence of in use reliability information about no-lead, especially given that creep is significantly different between SnPb and no-leads. While they
Electronics Forum | Thu Apr 08 04:52:24 EDT 2004 | Dougie
We are concerned about the issues you mentioned and more, however we have no option but to change over due to legislation. A high percentage of our market share is in Europe and Japan, who of course have already embraced the no-lead change. We simply
Electronics Forum | Fri Aug 11 22:14:59 EDT 2017 | dawson
Hi Adonys, What's ICP 1-3? Do you mean IPC? 1. Excess Plating- no excess, but filled with something which generated in the process of copper plating. 2. Dark Vias - it's oxidized. and the solder mask printing is not aligned. The board is failed. M
Electronics Forum | Wed Apr 26 10:27:37 EDT 2006 | slaine
weve hand soldered a few components that were tarnished with no problems, also the tarnish is electrically conductive if it helps.
Electronics Forum | Thu Apr 20 17:16:02 EDT 2006 | GS
Silver tarnish on lead could compromise the soldering, mainly in case of No Clean process. Make sure components are correctly packaged and stored. Check the vintage ( Manufacturing Data Code) and in order to avoid them to get old on shelf make sure F
Electronics Forum | Thu Dec 14 10:14:04 EST 2000 | PeteB
Jacqueline, Asuming you mean immersion silver: Advantages - Very flat finish compared to HASL, more easily solderable than bare copper with OSP and more process tolerant than this in our experience, reasonable shelf life, cheaper than immersion gol
Electronics Forum | Wed Dec 13 20:30:59 EST 2000 | Dave F
Immersion Silver PCB Surface Plating - Dennis VanBuren 14:21:24 02/01/2000 [Wudja mean "not much luck" searching the archives? What is this haggis???][Is that like saying "what is this chopped liver??"]