Electronics Forum | Wed Mar 08 03:44:46 EST 2006 | lov3ly_9irl
Hi, Can anybody know a company that sell vacuum filter for Juki and Yamaha machines? Tks. Lauren
Electronics Forum | Wed Mar 08 07:51:27 EST 2006 | sagan
Any SMC resseler may have the Venturi filter for the Juki... as for the Yamaha, i don't honestly know.
Electronics Forum | Fri Mar 10 03:30:44 EST 2006 | lov3ly_9irl
Thanks
Electronics Forum | Wed Mar 08 16:52:07 EST 2006 | darby
Which model Yamhah are you talking about and what is the make and model # of the manifold block for the micro ejectors? If it has the Koganei ME05M series then your local rep can supply the filters. It is a good idea to get spare O-rings for the filt
Electronics Forum | Thu Dec 01 04:32:28 EST 2016 | Rob
We've run for about 2 years with SN100C on a Stainless pot, and all looking OK at the moment - we have just drained the pot and swapped to a similar solder (customer request)so we had a good look as we were interested to see what was happening. To be
Electronics Forum | Fri Jan 22 02:24:03 EST 2010 | jlawson
In old days when Zevatech rebadged JUKI machines their was a dos based program that generated JUKI format files from ASCII Centroid data....(would have to premerge with BOM etc) it also could export from JUKI formats to ASCII. SO like others I think
Electronics Forum | Thu Aug 27 15:00:55 EDT 2020 | djeffries
Is Juki support not helping you out with this? We get tremendous support from Juki support here in the US on troubleshooting.
Electronics Forum | Mon Jan 18 11:49:30 EST 2010 | tech1
Yes it can, I think
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Mon Aug 24 17:05:51 EDT 2020 | kumarb
Aurash, we own Yamaha machinery but just throwing it out there...are the movements of the motors smooth or with friction? Is it possible that the linear screw rods (as in our machinery) require to be lubricated? There are special lubricants for each
