Electronics Forum | Wed Mar 31 00:40:22 EST 2004 | darburch
We have recently acquired a dynapace shuttlegate. Yes we bought used and it did not come with a manual. If anybody could let me know where I could get even parts of the manual(functionality, parts list) I would greatly appreciate it, Dynapace wants $
Electronics Forum | Mon Oct 10 11:32:04 EDT 2005 | davef
Conveyor equipment suppliers are: * FlexLink Systems, Inc.; 6580 Snowdrift Rd; Allentown PA 18106; 610 973-8230 F 610-973-8345 http://www.flexlink.com * JOT Automation Inc.; 1201 S. Beltline Rd.; Coppell TX 75019; 972 393-5564 Fax 972-745-9013 http:
Electronics Forum | Tue Aug 11 15:58:10 EDT 2020 | gilbe12586
Looking for FUJI CDC-4200-2 conveyor manual, belts, and bearings.
Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Mon Jan 15 15:18:13 EST 2007 | jaimebc
We have an oMniflow 7 as well, and looking at the calibration procedure, it indicates that turning the pots ( total of 5 pots. 4 on the lower board and one on the upper board )fully counter-clockwise is the FIRST step of a series of tests. Then you w
Electronics Forum | Thu Jul 11 14:10:55 EDT 2024 | jsmith01
Would anyone have a manual/schematics for a Jot J204-50.4/12 conveyor? Thank you
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Tue Jan 16 07:51:23 EST 2007 | leemeyer
I have found a screen in the software that appears to be some setup data for the conveyor. I cannot find any information in the manual refering to this screen. If you open "SCREENS" then "DEBUG DATA" then "CONVEYOR" there are some setup parameters. D
Electronics Forum | Mon Jan 15 15:42:45 EST 2007 | realchunks
Dback is right. You're missing part of your manual. Once you perform steps 5-7 you should get an indication that you calibrated correctly. Man, it's a cardinal sin to recal conveyors once you have programs adjusted. Why did you feel the need to
Electronics Forum | Mon Jan 15 16:14:15 EST 2007 | leemeyer
This is a used oven, new to us. No product has been setup on it yet. We were establishing som baseline profiles and noticed that the actual profile read didn't even come close to our optimal profile. Further investigation proved that the belt was to
.gif)
winsouce.jpg)