Electronics Forum | Fri Mar 11 10:00:22 EST 2005 | ???
Anybody out there know of a good (2nd) source to purchase single magnetic board supports used on quad/samsung machines. These are spring loaded and contact the underside of the board in the pick n place machine
Electronics Forum | Fri Mar 11 10:51:29 EST 2005 | mfoster
Samsung Back-up pins available from Dynatech for $30 each. http://www.DynatechSMT.com
Electronics Forum | Thu Oct 15 09:05:16 EDT 1998 | mike weekes
Hi folks, I'm looking for PWB fab houses (for single sided, doublesided and multilayer boards) that you have worked with who are reasonable on price, excellent on support/response and great on quality. I'm at 800 323 9562 Mike Weekes - The Phoenix
Electronics Forum | Sun Oct 18 00:04:14 EDT 1998 | Kallol Chakraborty
| Hi folks, | | I'm looking for PWB fab houses (for single sided, doublesided and multilayer boards) that you have worked with who are reasonable on price, excellent on support/response and great on quality. | | I'm at 800 323 9562 | | Mike Weekes
Electronics Forum | Tue Jan 13 19:16:03 EST 2004 | pjc
Dedicated tooling uses what MPM calls an "H" tower. You mount the board support plate (dedicated tooling) on top of the H tower. If boards are only single-sided SMT, meaning only components on one side, the board support plate is flat with vacuum hol
Electronics Forum | Wed Mar 27 01:06:12 EST 2002 | ianchan
Hi Guys, We are using two types of support Jigs for our PCB boards, during the paste printing, chip shooter, and IC mounting. The two types of support Jigs are : 1) "self-fabricated" aluminium support Blocks 2) "off shelf purchased" support Pins T
Electronics Forum | Fri Jan 14 03:52:34 EST 2000 | Scott Davies
To any users of Camalot Adhesive Dispensers... Do any of you know where I could get hold of the spring loaded magnetic board supports used on, for example, the 3800 machine. Camalot's representatives here in the UK, Speedline, are asking a ridiculou
Electronics Forum | Wed Jun 02 09:21:10 EDT 2004 | James
They take the place of the tooling pins. They magnetically attach to the table. Board comes in, table raises, Red-E-Set supports the board, prints, done. You just have to do the initial setup before running. We bought 4 units for each machine. J
Electronics Forum | Wed Nov 20 16:27:15 EST 2002 | pjc
FYI: MPM does in fact offer alternate board support tooling than the vacuum box system. They have the X and Y snugger tooling, which clamps the board and uses magnetic support pins. If you are looking at a used UP2000, check to see what tooling it ha
Electronics Forum | Sat Jan 22 15:11:50 EST 2000 | Ace
We had a set custom made for a fraction of the cost Camalot wants for them. Just take some measurements form your current set. It won't be too difficult.
.gif)
.gif)
