Electronics Forum | Tue Feb 19 16:19:26 EST 2008 | edatasys
Check out http://www.solderstar.co.uk/wavePro.html This tool measures all key wave solder information with a single pass. Wave/PCB contact, immersion depths, etc. Also has a reflow pack to allow use on reflow, 9 channels with predictive software. B
Electronics Forum | Mon Jun 22 06:35:19 EDT 2020 | vinitverma
Sapphire has a Line Array camera on either side. So all components on all nozzles are recognised in a single pass. But Sapphires are tough to maintain. And yes, it can handle max. 25x25mm components with the Line Array.
Electronics Forum | Tue Jan 24 21:29:06 EST 2023 | stephendo
What about nitrogen purity? Erza won't say anything other than you need 99.999% pure nitrogen. We are looking at another company that says the same. At a previous place we switched from dewers of liquid nitrogen to a single pass filter. I could see
Electronics Forum | Wed Dec 08 20:47:01 EST 2021 | cbeneat
It's funny, we expanded with 2 additional lines a few years back. Set them up for exactly what you're saying, the end of one is 5 feet from the beginning of another. Operator would only have to pull the magazine from the mag loader, turn around and l
Electronics Forum | Wed Jul 06 15:26:12 EDT 2022 | glasscake
No experience with low temp solders for PIHR but we do use standard lead free 245-255 peak profiles on high temp connectors frequently. Honestly the added cost of the high temp connector pays for itself in labor. I almost always use oversized apertu
Electronics Forum | Tue Dec 29 10:36:38 EST 1998 | Earl Moon
| I have been working on this process for a couple of weeks and I know that there are a few other companies in Europe and Japan who are also playing. | | Is there any one who has been running this process in production ? | | Yes I do mean reflowing
Electronics Forum | Tue Dec 29 12:18:17 EST 1998 | Ryan Jennens
| | I have been working on this process for a couple of weeks and I know that there are a few other companies in Europe and Japan who are also playing. | | | | Is there any one who has been running this process in production ? | | | | Yes I do mean
Electronics Forum | Fri Oct 29 11:59:35 EDT 2010 | rway
We currently have two YTV-M1 inline-systems from YesTech. I have been using them for around 3 years now. They are descent machines. If you decide to go with YesTech, go for the F1 system. This will give you the ability to upgrade with side camera
Electronics Forum | Tue Aug 23 16:57:29 EDT 2005 | HOSS
50% of seeing it in a single pass. The only time we do this is if we have a board off the line that has delaminated. We'll run a sample of boards through bare to confirm that we have a bad batch. Even if we see no failures on the bare boards, we'l
Electronics Forum | Thu Dec 09 12:29:39 EST 2021 | stephendo
With the bottom followed by the top set up, how do you even come close to balancing that? For a lot of boards that I have seen you would need five or more top lines just to handle one bottom line. Or have the bottom line on a very low duty cycle. B
.png)
