Electronics Forum | Fri May 18 23:48:02 EDT 2012 | mspcb
Hi, Since you're looking information about flexible printed circuits,a book entitled "Printed Circuit Boards R. S. Khandpur" could give you lot of information about flex circuits from Design, Fabrication, and Assembly Phase. The book contains compr
Electronics Forum | Thu Oct 18 12:15:03 EDT 2018 | teresat2
The numerous traits of an electronic assembly comprise high volume assembly, BGA, AOI and 3 dimensional solder paste inspection. The value incorporated features of these assembly services comprise low loss, blended technology assembly, many layer, du
Electronics Forum | Mon Nov 29 11:37:51 EST 1999 | cpitarys
Hello Jason, I will look for the best price and service support to start. Also request an in house trial at the vendor. Jason, are you looking to remove a no clean paste or water soluble paste? Single Chamber Equipment: Most stencil cleaners opera
Electronics Forum | Tue Oct 17 12:15:19 EDT 2000 | NLykus
Dave, Current process is Insert through hole components topside Dispense SMT glue Place SMT components bottom side Glue cure Insert 1 through hole component by hand Wave Wave temperature is 480oF Topside preheats in D.O.E ranged from 99oc to 108oC
Electronics Forum | Mon Mar 09 16:36:38 EST 1998 | Jim McLenaghan
| We have a double sided pcb that is surface mount on both sides. Now a Through Hole connector has been added. Appart from hand soldering does anyone have info. on reflow soldering the part. The connector is 0.1mm pitch, square legs. | 1) Do you need
Electronics Forum | Thu Nov 25 20:28:43 EST 1999 | cklau
hello, One way to prevent copper land delamination is to applied Anchoring spurs also referred to as "tie-down tabs" or "rabbit ears".These are a metal projection around a land.This features is fully captured by the cover lay (cover coat) that is n
Electronics Forum | Thu Jun 25 14:45:55 EDT 1998 | Chrys
| I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will sold
Electronics Forum | Thu Jul 20 17:01:26 EDT 2000 | Bob Willis
Here is some further information on SDSRS process, but please purchase a copy of the report from t he SMTA as all the money goes to charity. In the UK the SMART Group raised over �3000 for the homeless. SMTA have been raising a lot of money for the G
Electronics Forum | Thu Aug 10 13:12:10 EDT 2000 | Bob Willis
You may care to review the following from my Circuits Assembly page on line. "HOW FLAT IS FLAT AND DO WE NEED FLAT CIRCUIT BOARD, YES WE DO ? As production problems go there is one that keeps reoccurring time and time again. The blame is usually di
Electronics Forum | Thu Jul 20 15:08:53 EDT 2000 | Bob Willis
Yes no problem here it is in a nut shell. The sponsor of my CD ROM on this process was Loctite who specifically developed a glue for the process to cure in less than 10seconds. Have a word with these guys they may even have a few CDs. PROCESS SEQUEN
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900
