Electronics Forum | Mon May 24 10:17:54 EDT 1999 | john thorup
| Can anyone steer me towards a supplier of heatsinks suitable for use on a PQFP 160. Before you shoot me down in flames, I know that I am not going to get much heat away from the die because of the plastic but the application is such that the board
Electronics Forum | Tue Jul 14 13:23:59 EDT 1998 | Tom
I am looking for some general information with respect to BGA devices on circuit boards. I work for an automation company and am curious to know who's doing what with BGA placements, specifically the heat - sink application to the BGA device. General
Electronics Forum | Fri Jun 06 18:44:26 EDT 2003 | davef
No, no. It's koscher to have thermal planes. You just need to: * Work with your fabricator to keep the layup balanced. * Relieve the plane so that it doesn't cause assembly problems. While probably not directly for your part, it gives a starting p
Electronics Forum | Thu Jul 20 16:28:55 EDT 2000 | Bob Willis
Most robust wave soldering machines will cope with lead free alloys. The temperatures in air that we have run has been between 260-265C. In my opinion the dross generation has not been significantly effected. I was doing a workshop for a well known
Electronics Forum | Fri Sep 26 08:15:01 EDT 2003 | Gabriele
Forced gas (hot air or N2 according to solder paste or flux) will be the solution. To rework Ceramic (Aluminum lid Heat Sink)BGA (32 mm square ) or Ceramic Colum Grid Array C-CGA 1,25 and 1,00 mm colum (pitch 42,5mm square), also them capped with a
Electronics Forum | Thu Mar 12 21:14:16 EDT 2009 | davef
Mask: * I/O connector contact surfaces * Bus connector contact surfaces * Configuration jumper blocks * Test points * Surfaces that contact heat sinks (heat sinks are removed prior to coating) * Board mounting holes * Adjustable potentiometers * P
Electronics Forum | Fri Mar 04 01:08:19 EST 2011 | kemasta
Thanks davef Bridging:- There is no heat sink on the BGA, the heat sink will be fix after relow. I do believe paste had something to do with it, but currently this defect didn't appear so oftenly, so we think that the main root cause is not from the
Electronics Forum | Tue Mar 07 19:50:14 EST 2000 | Charles Jim
Hi there, I need some edge emitting laser mount, acting as heat sink also, seen once, from one Japanese company, if you have related info, please email me or reply here. Thanks, Jim
Electronics Forum | Tue Mar 07 19:50:14 EST 2000 | Charles Jim
Hi there, I need some edge emitting laser mount, acting as heat sink also, seen once, from one Japanese company, if you have related info, please email me or reply here. Thanks, Jim
Electronics Forum | Mon Dec 18 17:56:26 EST 2000 | Dave F
Does the thermal conductivity of a copper trace on a printed circuit board change as the copper oxidizes? Is the oxide on copper a thermal insulator? If so, should it be considered in an analysis of thermal resitivity between a ground plane and a h