Electronics Forum | Tue Nov 13 04:47:19 EST 2018 | dhammika
hi Siplace Hs-60 defected due to below error Error- • Machine error:2271 Can bus: reception call aborted with time out seg:0 DEV: head 2 #:1 (this is not only head 2 ,error raise with all head interm
Electronics Forum | Thu Sep 26 13:55:54 EDT 2019 | ttheis
One of our GSM1 machines occasionally stops running in the middle of a program and I haven't been able to figure out what is causing it. When the issue occurs, the "BM" (bus master) light on the SYS68K card drops out (turns off, no activity) the boa
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Thu Dec 09 04:11:54 EST 2021 | cirsol
Hello Forumers, I'm hoping there might be a SiPlace expert or two trawling the forum. We have an S25 machine that essentially has a failed MC harddrive and we're trying to rebuild a new one. Attached are a few images and perhaps something shown her
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co
Electronics Forum | Wed Jun 01 22:42:50 EDT 2016 | dinhhuunam
CAN Node Not Responding This problem can be caused by either: 1. Faulty Node 2. CAN bus cable disconnected. 3. No power to CAN Node.
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Sat Nov 21 07:57:48 EST 2015 | micropak
Actually I from the SC I am able to ping both the MC and the LC. By switching the monitor display the MC shows text the last line of which says"Config completed enabling task". The ICOS display is a red cross hair. All the axis cards show green LEDS.
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
