Electronics Forum | Fri Jun 12 01:17:52 EDT 1998 | Erhard
Are you using extra feeder tables that you can setup off line and than just exchange for the ones you had in the machines for the previous batch? This way the Siplace should not be too bad. Otherwise for fast change and low volume you might look at m
Electronics Forum | Thu Oct 12 04:04:23 EDT 2006 | odedkal
hello everybody ! does anybody have an experience with the hover davis feeders for siplace machines ? I am interested mainly in the triple feeder. is it better or easier to use than the original ? (siemens) any replies will be wellcomed, thanks o.k.
Electronics Forum | Thu Oct 12 08:22:44 EDT 2006 | stockley
We have one of the triples, it advances much more smoothly than the Siemens feeder and is easier to load. It is a well designed feeder, the drive mechanism uses some kind of plastic gears - but we haven't had it long enough to know if how well they w
Electronics Forum | Thu Oct 12 12:51:39 EDT 2006 | john_smith
Hey Brian how are you doing? We also have one of these feeders and it works great! The best feature is the being able to reverse the feed wheel to backfeed parts. Just talked to the guys at Hover-Davis yesterday and they have had feeders in service
Electronics Forum | Mon Oct 21 03:27:15 EDT 2019 | btkhoo68
we would like to monitor ASM siplace feeder, cycle time, nozzle.event using SCADA. Anybody able to provide memory address allocation for above data value to read by SCADA
Electronics Forum | Mon May 06 16:34:20 EDT 2019 | tey422
First of all, I am not familiar with the machine you stated. But there is something you should check out. That is if the nozzle tips having solder paste stick to it or not. If nozzle tips having a fresh paste stick to it, the component might not a
Electronics Forum | Thu Jan 21 02:26:30 EST 2021 | baldoino
I would like to sell used pick and place feeders for Siplace. How can I offer them (70 x 8mm; 20 x 12/16; 05 x 24mm.
Electronics Forum | Thu Jan 21 14:12:28 EST 2021 | davef
In the navbar on the left margin, select "Used SMT Equipment" In the dropdown, select "Add Equipment" Complete the description form You're on
Electronics Forum | Wed Jun 17 19:44:31 EDT 1998 | Eldon Sanders
Rob, I think the change over on the Quad QSP2 is about as easy and fast as it can get without swapping out the feeder bases. In a high mix environment I think it is worth looking at. Regards,
Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh
REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.
