Electronics Forum | Tue Jun 19 17:42:38 EDT 2007 | dyoungquist
We run a TP9 machine and had a very similar problem with it. On a TP9 machine there is a power supply board where all the voltages are generated. It is located on the bottom side of the unit. The problen was with one of the fuse holders. The co
Electronics Forum | Tue Feb 18 14:46:38 EST 2020 | bilalfarooqi
Hi all, We were able to fix the issue. We replaced the MOT cards with the MOT cards in the good machine. That, however, did not resolve the issue. The issue was very basic; one of the fuses (fi fuse) located to the left of the MOT cards became open.
Electronics Forum | Mon Oct 24 13:22:06 EDT 2022 | micropak
May I know the location / country ?
Electronics Forum | Thu Nov 10 17:48:52 EST 2022 | furman
Where are you located? Still interested?
Electronics Forum | Tue Aug 13 10:35:16 EDT 2019 | sankarseptember
In Siplace mounter if i remove feeder with component from feeder pallet in machine..and again i set feeder in same location machine does not to verify and indication become green.Is there any option for setup verification any feeder removed even for
Electronics Forum | Thu Apr 04 18:38:08 EDT 2024 | ronh22
I have the rear panel off and I can see the Drive but there is very little clearance looking down or working. Where are the fuses located? We also had the breaker pop a few times on out main breaker before this happened.
Electronics Forum | Thu Jun 09 18:59:49 EDT 2016 | spoiltforchoice
You'd have more luck looking at where it is located in the circuit than posting a picture a of brown brick with contacts either end. Its fairly chunky so sure it could be a ferrite of some kind (but they are normally black) or indeed a Fuse, self re
Electronics Forum | Fri Nov 19 13:37:10 EST 1999 | JAX
I have recently started programming Siemens equipment (Monday) and am a little confused on some issues. When inspecting BGA packages does the machine locate a corner ball and use it as an anchor to locate the rest? If not how does it know that it has
Electronics Forum | Mon Sep 29 13:36:01 EDT 2014 | dustin
I came into work this morning to an error on one of my printers. After powering on machine, the error MACHINE DOWN popped up in the top left corner of the screen. I have the giant manual and could not locate a solution for this error. I have checked
Electronics Forum | Mon Nov 23 13:46:14 EST 2015 | dilogic
It is written on power-up screen after booting USOS (green letters). I am attaching image of mine, but with newer VME630 vision. If yours shows AIS3500 there, it is probably a problem with video DAC inside that box (located on the machine rear end, a
.gif)
