Electronics Forum | Fri Jan 08 10:18:28 EST 2016 | cgreiner
I will email my notes to you Good luck and best regards
Electronics Forum | Sun Jan 03 04:26:36 EST 2016 | sarkhosh
Hi Dear sir I have a question,My F5HM machine have mc hdd problem and dosen't boot. would you please let me know where can I download or find the mc installer floppy. with regards Masih Email: sarkhoshm@gmail.com
Electronics Forum | Tue Nov 17 07:37:19 EST 2015 | micropak
Hello I got a SiPlace 80-S20 machine which had a damaged hard drive in MC. I changed HDD and re-installed RMOS + MC from floppies. Then I turned on the machine (without any Line Computer). The software on Station computer wouldn't go past the "Soft
Electronics Forum | Sat Nov 21 07:57:48 EST 2015 | micropak
Actually I from the SC I am able to ping both the MC and the LC. By switching the monitor display the MC shows text the last line of which says"Config completed enabling task". The ICOS display is a red cross hair. All the axis cards show green LEDS.
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Fri Nov 20 10:44:46 EST 2015 | cgreiner
Hello > > I got a SiPlace 80-S20 machine which had > a damaged hard drive in MC. I changed HDD and > re-installed RMOS + MC from floppies. Then I > turned on the machine (without any Line > Computer). > > The software on Station computer > wou
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
Electronics Forum | Mon Oct 21 18:39:50 EDT 2019 | kheops
Hey guys, so awhile ago I started working as a machine operator at a Siplace SX line (4 Stations: sx2(cpp) - sx1(cpp) - sx1(cpp) - sx2(twin head)) and i noticed a strange thing. The displayed times of the stations don`t match up at all, not even clo
Electronics Forum | Wed Jan 27 08:31:13 EST 2016 | oxygensmd
You need to connect the MC (machine controller), SC (station controller) and the LR (line computer / linie rechner) to same network. The Siplace's network is really strange because this 3 machine will communicate together. You can give the right IPs
Electronics Forum | Thu Oct 06 06:31:45 EDT 2022 | hta1979
Hi all ! We changed the repick setting of a part in Siplace Pro. But when we sent it to the machine, the setting did not change. My question is,it possible that this option only works with the 505 station software? This is an F5HM,we have 406 softwa
.png)
winsouce.jpg)
