Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh
REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.
Electronics Forum | Fri May 06 18:19:45 EDT 2005 | Dr. Klein
hello all. i would like to know a process for sampling scrap lever from siplace mechine (madamas prog). what is the everage scrap level? how many times should i sample scrap level during assembly? what are the steps operator should do for fixing hig
Electronics Forum | Mon May 07 22:25:21 EDT 2001 | Doug Kester
Has anyone heard of a single or double tray holder plate for Siemens Siplace equipment (either OEM or aftermarket). This would be similar to the Universal, Quad, and Zevatech platens for trays that just clip on to the feeder holders. Have only a co
Electronics Forum | Tue May 08 08:26:15 EDT 2001 | caldon
Yes Siemens has a fixed tray feeder for matrix trays. If I remember correctly the tray will occupy 1/2 of the table.The feeder is a two part system 1) is the base 2) the the flat tray (just like what is used in the waffle pack changer). the flat tray
Electronics Forum | Wed Jan 19 11:44:47 EST 2011 | davemac62
I have a Topaz with 2 positions in the rear where component trays may be placed for limited tray component capability. There is not a lot in the manual on how to set this up. The Feeder Plate info is set up to allow Fix.tf. I have spec'd tray - fix.t
Electronics Forum | Thu May 10 13:53:36 EDT 2001 | stefwitt
If you get the price for the tray and holder from Siemens you will follow Dave's recommendation. To get the 0 point for the tray ( from where you measure the first pick position )you set up the tray on the 7th track ( type 51 ). After you sent the da
Electronics Forum | Sat Jan 22 05:08:15 EST 2011 | jeffr
For all Tray type components the machine will not pickup from the tray using the adjust assistant (f6). It will default to a position where you can place the QFP onto the nozzle yourself by hand.
Electronics Forum | Mon Jan 24 08:36:03 EST 2011 | davemac62
Thanks a bunch. I guess I did all the tray setup right. The adjust assist thing was kicking my butt!! On the right track now. Thanks again. Dave
Electronics Forum | Fri Jan 21 09:45:16 EST 2011 | davemac62
Thanks Jeff. Guess I didn't tell enough of the story. I can get the 1st part location taught (it looks like) but when I try to pick a part from the tray using adjust assistant (F6), the head changes to the appropriate nozzle and tries to pick from th
Electronics Forum | Fri Sep 01 11:55:27 EDT 2023 | tommy_magyar
In my previous job we fitted these connectors with bespoke gripper nozzles (ASM/Siplace) from bespoke trays made for these due to the high volume. It also reduces the risk of damaging the component further in case of a reject. However, at my current
