Electronics Forum | Thu Feb 05 02:17:41 EST 2015 | ermani9
Hi.. Hommer, I am not able to install the Vision tester software for ESV304 machine. It is giving an error in the installation "Unable to load HINST.dll" and software asks to re-install the same again. I tried a lot. but all in vain. Please help if y
Electronics Forum | Thu Feb 05 02:43:22 EST 2015 | sarason
Hi.. Hommer, I am not able to install the Vision > tester software for ESV304 machine. It is giving > an error in the installation "Unable to load > HINST.dll" and software asks to re-install the > same again. I tried a lot. but all in vain. > P
Electronics Forum | Mon Jan 11 17:19:31 EST 2021 | rmitchell
Problem resolved- The machine camera had crashed when the operator put the PCB in upside down (this was kept secret until intense water boarding). The crash seem to take out a chip on the vision processing PCB. It was visually damaged and looked lik
Electronics Forum | Fri Mar 01 10:45:54 EST 2013 | jaimebc
We currently have a problem with our Universal GSM 2. A part ins presented to the front or back camera but there is no image of the component. Just a dark screen, even though the light system is working. Any ideas on what the problem may be? I suspec
Electronics Forum | Wed Oct 22 06:06:54 EDT 2008 | stanyserrao
1CA64011 and 1CAFE011 UsedBy Display 1CA??011 Cause The Vision_type in part data is expressed using hexadecimal notation ("??"). If "??" equals 1E, 64, 78, 79, AC, or FE then boundary detection could not begin because the nozzle was bent.
Electronics Forum | Mon Sep 03 08:56:26 EDT 2001 | henriksn
Hi everyone, I work in a development firm, that has a small prototype department. We have recently invested in a small automatic SMD pick&place machine. When mounting over 100 different components, the machine runs out of feedercapacity, and the res
Electronics Forum | Fri Dec 13 11:21:19 EST 2002 | dphilbrick
Since you asked for more here is my $ .02. There are many different vision systems, camera and software combinations that will make each make and model machine work differently. For instance a 1999 Siplace machine might work best with a 1.5mm round F
Electronics Forum | Fri Jul 28 09:35:12 EDT 2006 | chrisgriffin
I think Siemens 80 S20 is a great machine. I worked on them for a few years, with very little problems. They are extremely easy to maintain. I think a complete PM took about an hour. The software is good and user friendly. You can change one over
Electronics Forum | Fri Apr 26 08:38:14 EDT 2002 | ian
We have had Mydata for eight years and Siplace for six. We have found that the Siemens is much more accurate and faster than the Mydata (about four times quicker). Although the Mydata is more friendly regarding the software, if the upfront preparator
Electronics Forum | Wed Sep 09 12:39:22 EDT 1998 | Chrys
| I am attempting to locate a kit to be used on surface mount equipment to determine the placement capability (CPk). Does anyone have information on where to purchase such a kit? Ideally this kit should be usable on placement equipment from various
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
winsouce.jpg)