Electronics Forum | Fri Feb 27 10:12:36 EST 2004 | stefwitt
The front plate of the S15 head gives you access to the signal amplifier boards. You'll find 4 potentiometers adjusting the voltage and the symmetry of track A and B. A digital scope turned to X+Y provides an image of a circle, which is been adjusted
Electronics Forum | Wed May 08 07:19:03 EDT 2019 | youngbuck
Hi Sankar, I have had experience with the SX and X2 so I'm not sure how similar ours is to yours but i can give you some suggestions. 1. As Thomas said you could do a vaccum check and make sure the 4007 nozzle has around the same settings as the ot
Electronics Forum | Thu Jan 21 02:26:30 EST 2021 | baldoino
I would like to sell used pick and place feeders for Siplace. How can I offer them (70 x 8mm; 20 x 12/16; 05 x 24mm.
Electronics Forum | Tue Nov 26 16:25:22 EST 2019 | admintest
tttyygy
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Sat Oct 10 08:12:50 EDT 1998 | Rick I.
we currently have a siplace line(80s/f) and are inhereting a fuji line from another site. I need an objective comparison between the two. What are the strengths and weaknesses of the fuji with regard to programming, operating and maintenance. any cav
Electronics Forum | Fri Jun 12 01:17:52 EDT 1998 | Erhard
Are you using extra feeder tables that you can setup off line and than just exchange for the ones you had in the machines for the previous batch? This way the Siplace should not be too bad. Otherwise for fast change and low volume you might look at m
Electronics Forum | Fri Jun 12 15:06:45 EDT 1998 | Marcos Silva
| You can prepare your setup off line, using additional tables, and exchange very fast just sending the new program and checking using a barcode reader. Also you can edit a setup program with mixed feeders between PCB families. You can decrease your
Electronics Forum | Fri Jun 12 11:54:55 EDT 1998 | Rin Or
| I am currently in the process of trying to justify new equipment in my factory. I currently have Siemens siplace 15 series machines. I don't feel thins equipment is right for high mix/ medium to low Volume. I am running up against a in house con
Electronics Forum | Thu Nov 18 00:28:02 EST 1999 | Scott McKee
Use Mydata. I've built huge backplane boards, round boards, 1/4" thick boards, 1"X24" boards, 1"X1" boards, L-shapes boards; all without any carriers or tooling. If you buy a MY15 you can increase the board size to 5'X2' (60"X24")... As for ovens,
