Electronics Forum | Sat May 08 11:53:52 EDT 1999 | Scott Cook
| My company has a product line that utilizes multi-up PCB's. In order to cut costs for this product line, I have been asked to look into ways of running panels that contain bad blocks. Our SMT equipment is quite capable of doing this, but I need to
Electronics Forum | Thu Jul 07 09:53:17 EDT 2005 | PWH
Agree with D.B. We have also had to replace the belt that runs the auto conveyor width function. It might look just fine, but it will skip teeth on occasion if stretched or worn. Reparallelling the conveyor rails can be done manually by skipping t
Electronics Forum | Sat Aug 22 09:59:44 EDT 2015 | linux
Hello all, Can someone tell me the step by step procedure to check xo,yo, mark read position using Fuji board. Cp6 Fuji.
Electronics Forum | Wed Jul 06 10:22:04 EDT 2005 | PWH
At times we have had this problem with our AP25 due to one of the conveyor belts slipping. Load a PCB and check to see that both conveyor belts are running at the same speed. If not, tighten the one that is dragging. Hope this helps.
Electronics Forum | Thu Jul 07 08:29:51 EDT 2005 | chunks
Check to make sure your conveyors are parallel. Also verify the the width to make sure the belts are supporting the board properly. Sounds funny, but I see this more times than anything else.
Electronics Forum | Wed Mar 23 09:32:34 EDT 2016 | dhollland
Can someone explain to me how the scan position of the lead check works and it measured? On our machine the scan position was at .2. I changed this to .1 and could not get a QFP to pass lead check. I then placed it at .25 and haven't had any failur
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Wed Mar 05 12:42:46 EST 2003 | scifi97
Thanks for the questions/interest Mike. I only work with the data provided by customers myself and do not know a lot about how it is generated, other than a vision inspection machine looks at a completed card and provides the x,y and theta variation
Electronics Forum | Sun Apr 15 20:58:17 EDT 2007 | darby
PCB > Origin > O* > Skip = No Data In > PCB > Mount > M* > Skip = No Data In > System > Parameter > Position > Waiting Pnt Check that the waiting point is not set at such a co-ordinate that the PCB sensor is seeing the gantry. The pcb sensor also h
Electronics Forum | Thu Aug 04 22:02:25 EDT 2011 | fujiphil
IP3 camera calibration, you need the following: 1. Part camera resolution Jig. 2. 10mm nozzle for nozzle centering. 3. Button jig (skip). 4. Glass board and Glass parts. 1. Conduct the Camera resolution. Set the following Delta values: X=+/-0.1mm;
