Electronics Forum | Wed Sep 01 02:48:49 EDT 2021 | cmchoue
Hi Experts, I'm looking for how to auto skip the AXI(X-Ray) inspection on X-out board,Did any folks have the experience on this? Looking for your advice. AXI machine,Virtox and Matrix Thank you CM
Electronics Forum | Sat May 08 11:53:52 EDT 1999 | Scott Cook
| My company has a product line that utilizes multi-up PCB's. In order to cut costs for this product line, I have been asked to look into ways of running panels that contain bad blocks. Our SMT equipment is quite capable of doing this, but I need to
Electronics Forum | Mon Mar 18 13:39:43 EDT 2013 | vpham
Please help, how do you skip x-out boards on a panel using Juki 2050 pnp machine?
Electronics Forum | Thu Jul 25 15:00:37 EDT 2002 | Claude_Couture
1: I use the fiducial mark as bad board mark. 2: First get the X sensor installed on the machine, then use method 1. 3: other methods: group boards according to which unit is X out. Then edit NC program to skip corresponding X out.
Electronics Forum | Tue Apr 23 15:19:35 EDT 2024 | tey422
The impact of course is a lot less for newer PnP, but for older machine there might be different story. What if the bad marks not being read correctly? The result would be "good" board being skipped, while "X-out" being loaded. That would waste mu
Electronics Forum | Thu Apr 11 11:24:55 EDT 2013 | markhoch
Thank you for your advice Eric. Different SMT Machine Platforms have different methods for handling these PCB Panels with bad circuits. (Commonly known as "X-outs"). Some platforms allow you to identify X-Outs simply by darkening in the first fid
Electronics Forum | Thu Aug 18 09:46:40 EDT 2016 | jbuckley
Put anything over one of the fiducials being used in the circuit, and run the board. It will stop, and on the top right a window will pop up. Click "Skip Current Module" and it will X-out that circuit. If you are using the fiducials on the rail, rath
Electronics Forum | Thu Feb 16 02:44:03 EST 2012 | fadzril
Dear all, Have anyone deal with X-Out boards? These defects are declared if one cavity or more from multi cavity boards are defective. There have been a request to use these boards in order to reduce the multi cavity board spoilage at supplier. Ho
Electronics Forum | Fri Jul 26 12:18:43 EDT 2002 | dougt
I'm told that the Contact Systems machines we have will are set up so that if you put a sticker over the fiducial it will skip that board on the panel. I think the machine might prompt the operator that it can't find the fiducial and the operator te
Electronics Forum | Tue Jul 30 11:31:37 EDT 2002 | Bob
Be careful when using a sticker, if it is too thick it can affect the print, you may get leakage which can cause the underside of the stencil to get dirty. Another option depending on the quantity is to segregate the boards so that you do not have t
