Electronics Forum | Wed May 27 07:53:41 EDT 2009 | padawanlinuxero
Thanks ! I will try your recommendations, about the flux and the preheaters, yes they seems to be ok I will bring down de conveyor speed because it looks like if it is to fast is set to 3.6ft thanks again!
Electronics Forum | Wed May 27 11:54:29 EDT 2009 | allwave
Armando, Make sure chip wave is pumping evenly across. These TD machines require a lot of maintenance (deep cleaning)to ensure all the holes on nozzle are open... My two cents, George
Electronics Forum | Fri May 29 02:08:08 EDT 2009 | cobar
Check that you are getting an even spray pattern from the fluxer.Check that the chip wave nozzle is clean and if possible feed the PCB in to the wavesolder unit at 90 � or 180�.
Electronics Forum | Tue May 26 06:56:40 EDT 2009 | xinxi
Hi! From your post, it seem like the wave did not really touch the component. You probably need to get the both wave height correct and that it hits the component.It is normal for solder to come through the PCB when using chip wave. The through-hole
Electronics Forum | Mon May 25 21:10:28 EDT 2009 | padawanlinuxero
Hello !! I have a problem with my wave solder oven, in one of the products we made has connectors on one side of the pcb and in the other one has SMT components the process is kinda tricky on the SMT components we use an adhesive and put to the refl
Electronics Forum | Wed Oct 01 01:15:35 EDT 2008 | benefon
If you have your panel programmed as blocks (as opposed to expanded) two quick ways come to mind: 1. either use block badmarks to mark those blocks that you want to skip or 2. goto Block Repeat Info and mark and set the block that you want to skip as
Electronics Forum | Tue Apr 11 15:23:43 EDT 2006 | Cal
Hi Shawn- If I can remeber....from my Siemens Days on the S15 or F Series Once you send the program over to the machine from the line computer...You can not skip. Remember, these machines in theory are not ment to stop running (i.e. Thus the feeder s
Electronics Forum | Sat Mar 18 07:43:25 EST 2000 | Dave F
Larry: I'd like to see your angle increased generally and that could fix your problem. Lots of other things can cause skips, such as: * Wave height, your might be high with 2" of contact * Flux contamination, activity * Component contamination * C
Electronics Forum | Fri Jul 26 12:18:43 EDT 2002 | dougt
I'm told that the Contact Systems machines we have will are set up so that if you put a sticker over the fiducial it will skip that board on the panel. I think the machine might prompt the operator that it can't find the fiducial and the operator te
Electronics Forum | Wed Aug 27 13:59:10 EDT 2014 | jimmyboz
Or else, as Dman may have been pointing to, duplicate the first fid sequence, and use it as the block skip mark, if found, then the next sequence is the fid it already found as a block skip mark....
.gif)
.gif)
winsouce.jpg)