Electronics Forum | Fri Jul 06 18:22:51 EDT 2001 | davef
Oooo, you are waving 0402. Tell us more about your wave and its set-up. Never seen this [knock on wood]. When is this skewing occurring, after placement or during cure? What�s the distribution? What happens when you slow-down yer placement rate?
Electronics Forum | Thu May 06 12:59:42 EDT 1999 | Clifford Peaslee @ SMTnet
We have been experiencing problems with our web server recently, and has caused periodic slow downs. We are working hard to resolve this issue, and it is our #1 priority. Sorry for the inconvenience, and thanks for your patience, Cliff
Electronics Forum | Thu Jan 29 18:01:20 EST 2004 | davef
Rethinking to Ramp / Soak: Yano, staying with ramp might not be all that bad after all, just decrease the ramp / slow-down the conveyor.
Electronics Forum | Thu Oct 04 20:22:45 EDT 2012 | hegemon
SWAG may be correct. The program files, the defect data, and images do pile up. You will also experience this is you have a lot of components that are not linked to your libraries. These too will add up over time, and cause considerable slowdown. '
Electronics Forum | Wed Nov 21 10:41:03 EST 2001 | arzu
Hello, Sometimes you have no choice other than putting uvias in ubga's-pads. I know examples of high-end mass production of products with ubgas having voids. (no problems, but always voids visable in x-ray) I also performed a DOE a while ago to avoid
Electronics Forum | Mon Jan 24 11:07:30 EST 2022 | jineshjpr
Hi, In general Tantalum D & E case packages prefers 12mm Reel with sufficient height. Make sure that no external force has been applied to the reel ( where it causes pocket deformation) thus leads to prevent smooth component release. Slowdown the noz
Electronics Forum | Fri May 07 12:25:44 EDT 1999 | Clifford Peaslee
We have identified the problem with the network. The network we are hooked into, is currently shared with other web servers, and one of those servers had a renegade MP3 site which drained the network's resources. That server was shut down, and proces
Electronics Forum | Thu Jan 21 14:05:47 EST 1999 | Clifford Peaslee @ SMTnet
Some may be experiencing problems with slow connection speeds to SMTnet, but I want to make clear that it is not our server that is causing it. The problem exists in AT&T's network, which I presume is clogged at this time. If you want to check out f
Electronics Forum | Fri Dec 17 14:13:18 EST 2004 | Claude_Couture
I have done this several times in order to save my butt: adding liquid flux in a jar of not so fresh paste, stirring it slow for 2-3 minutes, to make it usable. Of course, use no-clean flux for no clean paste, etc. During one production slow-down,
Electronics Forum | Thu Jun 15 05:48:20 EDT 2006 | greg_diaz
Your concern should be do you have a glue process that can keep up with the FCP6. We ran a GL541 in line with a CP643 which the glue machine was actually a bottle neck because if you run SOIC's which require more glue dots then it will slowdown the
.gif)
