Electronics Forum | Fri Sep 20 09:03:32 EDT 2002 | Brad Fruend
This might be totally wrong but if your using a 16 pitch reel in a 8 pitch feeder you are going to have to feed the feeder twice before it will be advanced far enough. This should be in your F4G or MCS30.
Electronics Forum | Fri Sep 20 09:07:21 EDT 2002 | cyber_wolf
You are right. It is getting indexed twice. Once by the feed lever and once by the feed cylinder.
Electronics Forum | Tue Sep 17 07:42:27 EDT 2002 | cyber_wolf
Hi, We have a serious problem bending our 24mm tape covers. In particular we are feeding a 24mm 16 pitch tape on a 24mm P8 feeder.The component is a plcc28,the tape cover is a AMCD3107 5.0 When the tape covers come in from Fuji the fingers that cove
Electronics Forum | Fri Sep 20 19:06:09 EDT 2002 | mjabure
The way it works is the first index is done with the feed cylinder, and the final is done using the cam during pick. You might want to check to make sure you're getting a full, complete stroke out of your feed cylinder, also make sure the mechanism
Electronics Forum | Fri Jun 25 13:00:48 EDT 2004 | haviland
Hi--We deal in used and recond. equipment in the Midwest, and have available a 1999 Amistar #7100FV w/ a nice complement of feeders, (6) pick up heads, rated component placement at 18,000 pph. Does .0402's, .3 BGA w/ 20 mil pitch, Full vision system,
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Mon Feb 14 13:25:52 EST 2005 | gregp
EIA-481 standard allows the maximum pitch on tape to be 4mm less than the tape width (12mm width and larger). So it is within the standard allowances. As for how common 20mm pitch on 24mm tape is I can not say. I am surprised a 24mm tape feeder ca
Electronics Forum | Mon Feb 14 14:46:42 EST 2005 | russ
We use Samsung and our 24mm feeders have 8,12,16,and 20mm pitch settings. I have found 20mm pitch quite common. My favorite is yhe 12 on 12 our feeders don't support that, we have to put them up on 16mm feeders our cycle them 3 times on a 4mm pitch
Electronics Forum | Sun Feb 13 14:22:17 EST 2005 | griinder
Has anyone ever ran into a 20mm pitch on a 24mm tape and reel. Our software doesnt have a setting for 20mm. we found a way around it, but i was curious as to how common this pitch is, and if other software or feeders have a 20mm setting.
Electronics Forum | Tue Mar 30 10:57:54 EST 1999 | Steve Gregory
Hello, I'm a student assistant in a research project that deals with the simulation of PCB assembly systems. At the moment I collect information about SMDs. My problem is how to assign the correct feeder width to various devices in a simulation. Is
