Electronics Forum | Fri Aug 30 10:35:54 EDT 2013 | nophsem
Data base Utilities --> Download MOD Codes to assembler) and the motor error # 5 appeared instantly in the handheld.
Electronics Forum | Mon Jan 16 09:50:38 EST 2023 | mra
Hi Fern, I'm getting the same error on my CP40 and cannot clear it as well, did you finally find out what to do to solve it? Thanks in advance!
Electronics Forum | Tue Oct 20 23:14:01 EDT 2015 | kiwiguy12345
Hi, I have struck a problem with the X axis on my Juki 740. As soon as I "home" the machine the X driver displays the code "961" Does anyone have any ideas as to a solution for this problem? Thanks!
Electronics Forum | Thu Sep 08 13:07:18 EDT 2016 | claudea2
Hello Bob, we changed the nozzle z parameter until we got limit errors and backed up 1 mil. There was a slight reduction in the limit errors on the pickup of the component but it is still a problem. With the mod code we adjust the soft z height to ab
Electronics Forum | Thu Sep 08 15:22:32 EDT 2016 | bobpan
If its a tall part and you are trying to scan it lower than 200 or so...you can have this problem (limit error). Thinking of things to look at.....Is your z-rod spring sticking? Push up on it and it should spring back with NO hesitation...if it does.
Electronics Forum | Thu Oct 06 11:18:47 EDT 2011 | tpappano
That message is what you get if for example, if you press "stop" while a board is being placed. While "interrupted" you can for example, press "exit", go make adjustments to mount data or whatever, return to "running", then the board program, then p
Electronics Forum | Thu Aug 25 07:43:24 EDT 2016 | claudea2
We have been having a recurring error on one of our Quad 4Cs. When it picks up the first of 8 47uF SMT capacitor it stops with a limit error. If we do 2 consecutive function 30s, the problem goes away until the next board. The first function 30 re
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Thu Oct 06 17:34:07 EDT 2011 | jrsmachine
Hello Tom. Thks for your response. I tryed all your suggestions. No luck. This is how it happened: Several weeks ago I allowed an inexperienced unsupervised operator to work on some program changes. When I checked back afew hours later I noticed
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
