Electronics Forum | Thu Feb 15 15:23:12 EST 2007 | bvdb
The IP-1 vision error is" "Processing Error" er 401F 4003 which the FIP-I Operating Manual says the cause is "The actual number of leads on the part exceeds the number of leads in the Part Data". I have checked and re-checked the part data, lead
Electronics Forum | Thu Feb 15 17:00:37 EST 2007 | bvdb
Hi Jerry, Thanks for coming to my aid again. I have tried your settings of 10% for Lead check and pitch limit but still rejects the part. The vision image looks clean on the display. On one of the last trials I noticed that the part was picked up
Electronics Forum | Wed Nov 09 07:31:41 EST 2005 | smtspecialist
The part I'm having problem with is a simple 0805 resistor 0R the inspection is done optical not mechanical and 75% of the rejects rate has the message: one or too many bad leads found. and the other 25% the messages will give a Background or Contras
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Wed Aug 12 12:02:41 EDT 2015 | edwaterfall01
I think the heart beat message comes up if the vision had not initialized. You have changed that already stop I think it is something else. Have you some money a Restore of the Machine Configuration and Mapping and Calibration Data?
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Thu Jan 03 15:53:28 EST 2019 | cbeneat
We did figure out the issue. The plastic cover inside the LED lighting unit had a slight film covering it, which made the picture slightly hazy. We had to disassemble the LED module to get at it, cleaned it and it was fine. I didn't think this would
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Sun Nov 24 15:01:09 EST 2019 | dekhead
dekhead@att.net
Electronics Forum | Sat Nov 23 06:05:31 EST 2019 | hemantpang23
Hello Everybody, I have a problem with a DEK 265GSX, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broken wire and I have checked all
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
