Electronics Forum | Thu Oct 06 18:30:13 EDT 2022 | kojotssss
Solenoids, air flow sensors was checked?
Electronics Forum | Fri Jul 31 17:09:55 EDT 2009 | isd_jwendell
Don't know about Topaz, but on Essemtec machine using SMC ejector, there are separate solenoid valves for vacuum and release. The connectors are identical and side by side. If these connectors were swapped then I would have the symptoms you describe.
Electronics Forum | Fri Jan 18 07:01:41 EST 2008 | cyber_wolf
Hi, The solenoid that sits on top of the vacuum generator on my Fuji bare board loader is croaking slowly. Fuji will only sell me the entire generator assy. which cost more than I paid for the loader. The only markings on the solenoid are DC24V 540
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Thu Sep 13 14:18:59 EDT 2007 | slthomas
Just a little status update. When it's running and I monitor the I/O, the mount vacuum bit never turns over to 0. It may be turning over enough to run, but not long enough to see on screen. It stays at 1. When it errors, I can trip it by putting my
Electronics Forum | Sat Mar 20 09:04:39 EST 1999 | Stefan Witte
| Here is my question. We have several fuji CP's in our shop, every once in a while the first couple of parts placed are off the pads. When we move the parts further down in the sequence they are fine. What is going on? Has anyone had this problem an
Electronics Forum | Wed Feb 27 14:07:25 EST 2002 | Stefan
In order to kiss off the components with an air blow, there are two times to consider: 1. reaction time of the solenoid ( to shut off the vacuum and turn on the air ), 5-10 ms 2. time required to fill up an air hose, which leads to the nozzle. Assumi
Electronics Forum | Thu Nov 03 11:31:51 EDT 2022 | proceng1
You described cleaning the spindles and filters, but did you clean the nozzles? Perhaps you got some paste on the nozzle. Also, did you perform the vacuum and blow off testing? Make sure your solenoids are working properly. Is it all 6 heads that
Electronics Forum | Mon May 17 10:59:02 EDT 2021 | kumarb
Hi. Have an Emerald-X machine with FNC purchased refurb from Assembleon with mixed results at 3500 hours. Had it sitting idle for years due to assorted issues after their installation. Only now after much time and parts investment have the machinery
Electronics Forum | Sat Dec 13 08:03:46 EST 2003 | Stefan Witte
The only part, which could cause component misplacement on the rotary heads of the Siplace machine is the vacuum valve. I don�t know the official name in the part catalog, but I use to name it plunger. The plunger is moved in and out by a miniature s
