Electronics Forum | Mon Apr 27 16:46:44 EDT 1998 | Ryan Jennens
Does anybody know where I can get a SMD digital reel counter? I am looking for used; is there somebody that sells used, refurbished?
Electronics Forum | Sat Jan 11 14:37:20 EST 2025 | smtunion
We encourage you to check https://www.seamarkzm.com/products/x-ray-smd-reel-counter/ we have had success with these machines. they have service in USA and Mexico.
Electronics Forum | Wed Jan 15 16:56:25 EST 2003 | Garth
Buy an electronic counter and simply spool your partial reels to an empty reel. It takes my staff a couple of hours to count every component on partial reels (~50 different values) and I have an exact number rather than an estimate.
Electronics Forum | Wed Jun 12 08:01:04 EDT 2013 | mun4o
hi, i have problem with ceramic capacitor 10uF ±10% 16V X7R 1206.Problem is as follows:ICT ( Teradyne 8851 ) measured value 6 ?? 8uF ( about 70% of all lot).I decide that components ( samsung ) are defective.I buy one "type&reel" capacitors "Murata"
Electronics Forum | Sat Jul 30 01:36:04 EDT 2005 | Christofer Lapinskas
We are looking to have SMD components taped and reeled in Brazil. Are their any suppliers in Brazil? cl@latrex.com.br
Electronics Forum | Sat Jul 30 01:36:47 EDT 2005 | Christofer Lapinskas Latrex
We are looking to have SMD components taped and reeled in Brazil. Are their any suppliers in Brazil? cl@latrex.com.br
Electronics Forum | Sat Jul 23 09:19:17 EDT 2016 | dalpets
I want to place smd's by hand from tape strips using a vacuum pump. What is the orientation of polarised smd components on reels/tapes? Is there a standard manufacturing orientation, or are there variations? I understand some manufactures have part
Electronics Forum | Sat Jul 23 18:16:31 EDT 2016 | ttheis
This information is normally available in the component's data sheet (typically toward the end where the packaging is detailed.)
Electronics Forum | Fri Jul 29 13:42:38 EDT 2016 | gregp
The standard you need is EIA-481B. It details the taping of components from 8mm tape up to 200mm tape including component orientations. 8, 12, 16 and 24mm tape has the sprocket holes only on one side so it is easy to determine the proper orientatio
Electronics Forum | Mon Jul 25 09:11:25 EDT 2016 | spoiltforchoice
There 2 main rival standards for orientation in tape and because you can't really trust manufacturers to stick to one or the other or something else entirely it is always wise to check the datasheet. Typically an SOIC will have pin 1 the same end as
