Electronics Forum | Thu Mar 18 14:33:46 EDT 2010 | jdumont
Is your peak reflow temp exceeding the LED spec? We store our SMT LED reels on the rack with the rest of the discreets and have never seen this issue...
Electronics Forum | Tue Jul 07 12:33:39 EDT 1998 | smd
I am about to place a huge PO for ESD boxes. Our assemblies need to be placed horizontally in the stainless racks until wavesoldered, but after the wash they will be placed in the boxes. The boxes have a conductive film but they are still cardboard
Electronics Forum | Thu Jul 09 08:03:48 EDT 1998 | smd
OK, I'll take a little abuse as long as you guys are giving me all this great advice. I am concerned about what might happen when a drop here and there comes from the connectors and is absorbed into the box. The box is going to suffer from this. I am
Electronics Forum | Thu Jul 09 08:04:11 EDT 1998 | smd
OK, I'll take a little abuse as long as you guys are giving me all this great advice. I am concerned about what might happen when a drop here and there comes from the connectors and is absorbed into the box. The box is going to suffer from this. I am
Electronics Forum | Wed Jul 08 17:31:31 EDT 1998 | Dave F
smd: I think the idiom is "schmuck," rather than "putz." ;-) What are you concerned about? That the residual water in the 80 pin connector housing will flow down the boards and rot-out the bottom of your new boxes? Dave F | I am about to place a
Electronics Forum | Fri Jul 23 12:49:47 EDT 1999 | Tony
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Wed Jul 16 05:16:49 EDT 2014 | spoiltforchoice
This number is going to vary hugely depending on the machine, how you operate and how many feeders you have. Smaller outfits might have a single operative whose job it is to setup, load, run & program the line. Regardless of how changeover focused t
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
| 1 |
.gif)
.gif)
winsouce.jpg)