Electronics Forum | Thu Mar 18 14:33:46 EDT 2010 | jdumont
Is your peak reflow temp exceeding the LED spec? We store our SMT LED reels on the rack with the rest of the discreets and have never seen this issue...
Electronics Forum | Wed Jun 12 08:01:04 EDT 2013 | mun4o
hi, i have problem with ceramic capacitor 10uF ±10% 16V X7R 1206.Problem is as follows:ICT ( Teradyne 8851 ) measured value 6 ?? 8uF ( about 70% of all lot).I decide that components ( samsung ) are defective.I buy one "type&reel" capacitors "Murata"
Electronics Forum | Tue Jul 18 16:40:09 EDT 2006 | dphilbrick
We have a system where when we set up the line to run a job before the first part is placed an auditor verifies we have all the correct parts loaded on the machines in thier correct locations. We then run a first article. The board is inspected to in
Electronics Forum | Thu Mar 30 12:48:54 EST 2006 | krc
Pardon my ignorance on this subject but I gotta ask... When the SMT guys load partial reels, I'm told that they have to waste a few components in the process. It seemed obvious to me that there should be a kind of tape that can be added to the end
Electronics Forum | Thu Jul 04 05:24:45 EDT 2019 | kasun_elk
We have some small strips of SMD reels, when we use those reels in Siplace machine we can't identify exact part number of the strips because there is no any connection with reel and the strip. And while unloading reels operators insert wrong art
Electronics Forum | Sat Jul 23 09:19:17 EDT 2016 | dalpets
I want to place smd's by hand from tape strips using a vacuum pump. What is the orientation of polarised smd components on reels/tapes? Is there a standard manufacturing orientation, or are there variations? I understand some manufactures have part
Electronics Forum | Sat Jul 23 18:16:31 EDT 2016 | ttheis
This information is normally available in the component's data sheet (typically toward the end where the packaging is detailed.)
Electronics Forum | Fri Jul 29 13:42:38 EDT 2016 | gregp
The standard you need is EIA-481B. It details the taping of components from 8mm tape up to 200mm tape including component orientations. 8, 12, 16 and 24mm tape has the sprocket holes only on one side so it is easy to determine the proper orientatio
Electronics Forum | Mon Jul 25 09:11:25 EDT 2016 | spoiltforchoice
There 2 main rival standards for orientation in tape and because you can't really trust manufacturers to stick to one or the other or something else entirely it is always wise to check the datasheet. Typically an SOIC will have pin 1 the same end as
Electronics Forum | Sat Dec 19 22:46:18 EST 2020 | tueftler
Hi there. I'm searching for a good adhesive tape to fix the used smd tape on its reel after mounting. So that the reel will not spin off. It should be have a great glue, so that there is no glue residue after next opening the reel. Did anybode ha