Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Wed Apr 21 14:38:30 EDT 2010 | remullis
Newer Universal Conveyors use 4 wire smema and FUJI should accomodate this protocol in its config screens. Old Universal Conveyors and some machines used SMPI (forget how many wires), You can purchase the 4 wire smema cable from UIC and conversio
Electronics Forum | Mon Oct 21 15:14:53 EDT 2019 | compit
As you can see in machine B on pins 1-2, the circuit closes - give the button / contact here. The voltage you provide most likely applies to pins 3-4. In my (and in the SMEMA standard) it looks like this:
Electronics Forum | Tue Dec 29 11:38:40 EST 2015 | g2garyg2
Hi Tom If the DYNAPACE has SMEMA out all you need to do is place a two wire jumper into pins 3&4 or 1&2 depending upon DYNAPACE's SMEMA configuration. This will by-pass a Release signal and feed PCBs into the oven.
Electronics Forum | Thu Oct 02 10:55:37 EDT 2003 | caldon
Brad- The Spec can be downloaded free from IPC at http://www.smema.org/smema1.2.pdf (or IPC.org search for SMEMA Standards). As per Conveyor edge clearance should be .187" or 4.7mm. Regards, Cal Communications Test Design, Inc. www.ctdi.com
Electronics Forum | Tue Jan 08 17:46:38 EST 2008 | swag
If the phone jacks have two conductors in them, I would wire them to standard SMEMA connectors so that the upstream side goes to the middle two SMEMA pins and downstream goes to the outermost two pins. If there are 4 conductors in the phone jacks, y
Electronics Forum | Fri Feb 02 08:22:10 EST 2007 | davef
Try: * IPC-2221, 5.4.3 Datum Features * http://www-ese.fnal.gov/ese-dfe/SMEMA%20fiducial%20mark%20standard.pdf
Electronics Forum | Tue Sep 20 15:00:26 EDT 2016 | awhite
Got it!!!!! On the main Operator Screen for the MPM UP2000, and under configuration (when logged-in under maintenance), it gives you ONLY the settings that the machine is set to....there are no drop-downs or options available to choose from. Very fr
Electronics Forum | Wed Jan 21 11:02:41 EST 2004 | highfallsfunding
Hi Andreas. The SMPI is a proprietary Universal board transfer protocol. GSM platforms from about 1996 and newer have both SMEMA and SMPI. Although UIC later called it BPP1 (Board Pass Protocol) and BPP2, which is basically SMPI for lane-1 and SMP
