Electronics Forum | Tue Jul 11 21:41:51 EDT 2006 | fordf1502004
I am looking for some help and/or guidance. Our company is currently using a panasonic MPAG3 fine pitch machine, we just recently bought a universal conveyor for the downline operation, when I plug the smema cable from the panasonic into the universa
Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Thu Apr 15 10:10:50 EDT 2010 | rmalick
can someone help me with the key strokes to the panasonic mv2 and mpa3 machine secret screen. I know if is shift F7 ??????
Electronics Forum | Fri Apr 16 11:50:06 EDT 2010 | mobytahoe
Panasonic's passwords are the date backwards. For example, today's date would be: 01026140...they may use the month before day format...in which case it would be: 01020461
Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Wed Nov 18 14:42:22 EST 1998 | Dave F
| I heard somewhere that SMEMA has joined IPC, and that the association has decided to boycott Nepcon from | year 2000. Can anyone tell me if this is true | Nick: SMEMA and IPC are talking about merging (EP&P, 11/98, p 18). Below is a news release
Electronics Forum | Tue Sep 20 15:00:26 EDT 2016 | awhite
Got it!!!!! On the main Operator Screen for the MPM UP2000, and under configuration (when logged-in under maintenance), it gives you ONLY the settings that the machine is set to....there are no drop-downs or options available to choose from. Very fr
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Tue Sep 13 10:00:27 EDT 2016 | awhite
Switched out the mech. relay on the board loader, no change. Same behavior. Could not find a mech. relay on the printer... SMEMA wiring appears go directly to a PCB. And it is at that point that I run out of talent. If the machine weren't dedicate
Electronics Forum | Tue Nov 17 15:33:26 EST 1998 | Nick
I heard somewhere that SMEMA has joined IPC, and that the association has decided to boycott Nepcon from year 2000. Can anyone tell me if this is true
