Electronics Forum | Wed Sep 18 16:56:55 EDT 2002 | stockley
I started writing a long winded explanation about SMEMA and realised that it is just as easy to write about this as it is to talk about it on the phone. It just so happens that I have recently gone through this process so I believe that your vendor
Electronics Forum | Fri Jan 07 09:23:16 EST 2011 | ercdave1
I removed the front cover of the controller box and found a cable secured to the right plate with cable ties but no floppy. the cable has a 50 pin connector. maybe is an option on your machine that my didnt get. I hope tom has better luck. I am goin
Electronics Forum | Tue Feb 08 10:25:46 EST 2011 | remullis
Michelle, It's been years since I worked on these machines and mine were CS400E's. The next time this error comes up instead of powering down Unplug the RS232 cable that links between the PC and the processor board in the machine, I cant remember if
Electronics Forum | Thu Mar 10 15:13:31 EST 2005 | pmd
I agree with SirTec. Conflicts with other magazines slotted into machine often cause un reckognized magazine errors elseware. You can also try to re seat the first pair of MOT driver cards in computer this is whare mag data is stored. Also a loose ca
Electronics Forum | Mon May 16 22:06:22 EDT 2011 | danaherr
Downward looking camera not working. swapped cables on board and upward looking camera works when plugged into downward camera's connection on video card. Thinking maybe a cable issue??? manually moved gantry all over trying to see if intermitent ope
Electronics Forum | Mon Aug 27 08:37:13 EDT 2012 | rgduval
If you're still having this problem, talk to Al at MyData about replacing the ribbon cable that is wrapped inside the head, and connected to the two LED's. It's a bit of a pain to replace this cable, but, it did fix the problem for us. The other po
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Fri Oct 23 05:02:34 EDT 2020 | gabriel1blue
I change the settings to match another machine we have and that actually got the original drives working after replacing the belt. I ordered an adapter that will connect to the 26 pin flat cable and adapt to a 34 pin connector and pull the power from
Electronics Forum | Mon Mar 03 13:56:15 EST 2008 | daxman
Resolved! Jeeze...just after I posted this question I got the machine working. Someone had removed the cable for the wide camera and connected it into one of the ports that is unused. I noticed this when looking at the schematic. The cables had
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
.gif)
winsouce.jpg)