Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Tue Jul 11 21:41:51 EDT 2006 | fordf1502004
I am looking for some help and/or guidance. Our company is currently using a panasonic MPAG3 fine pitch machine, we just recently bought a universal conveyor for the downline operation, when I plug the smema cable from the panasonic into the universa
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Wed Sep 07 07:53:16 EDT 2016 | ttheis
Looks like I've got to reconfigure the fmi connections. Only pins 1 & 2 populated and when I jump the fownline pins the upline ready signal is activated. I'll reference the diagram and setup the connections for smema.
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Mon Sep 02 23:56:08 EDT 2013 | dekhead
Looks like too many signals there for a DEK SMEMA board to handle; trying to translate / ascertain what signals those are, to offer possibilities to communicate with DEK; However would pretty much guarantee a need for hardware change (personality car
Electronics Forum | Tue Dec 29 11:38:40 EST 2015 | g2garyg2
Hi Tom If the DYNAPACE has SMEMA out all you need to do is place a two wire jumper into pins 3&4 or 1&2 depending upon DYNAPACE's SMEMA configuration. This will by-pass a Release signal and feed PCBs into the oven.
Electronics Forum | Tue Nov 10 00:18:52 EST 2015 | ttheis
How is a board conveyor typically configured to unload into a conveyor oven if there is no downline machine to five a ready to receive signal? Do you just use a plc to activate the machine ready signal at a timed interval? Would you perhaps do the sa
Electronics Forum | Wed Nov 29 10:48:37 EST 2006 | bas Rottier
Hello, I'm looking for a protocol description of the SMPI interface (we would like to connect a SMPI machine to a SMEMA machine). Does anybody have description of signals (electrically) + waveforms + pin-layout + connectortype? THanks Regards bas.r
