Electronics Forum | Thu Apr 07 10:39:36 EDT 2005 | geb
I have a BTU International VIP98 reflow oven, running WINCON Version 2.00C on Windows 98. The light tower only lights green when the oven reaches temperature, and the other colours never light up. Do you know how to set the other colour lights to tu
Electronics Forum | Fri Apr 08 05:22:47 EDT 2005 | Bored
The light events are: Red - Alarm - Indicates that an alarm exists.This also occurs when the emergency power stop button has been used to stop the belt and turn off heater power. Orange - Alert - Indicates that an alert condition exists. Green - R
Electronics Forum | Wed Apr 13 10:56:41 EDT 2005 | emeto
Hello GEB, I had simular problem on Heller oven. Ina my case only orange light was on. I called the Rep. and after reinstall the software everything was ok. May be you should do the same.
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Wed Dec 14 13:44:14 EST 2022 | assuredtech
Do you have the electrical schematic? The matting connector should be right there at the machine frame just under the mounting hole for the light tower. Light Towers can be an "option" on machine configurations, perhaps your machine was not configure
Electronics Forum | Sun Jun 25 00:33:13 EDT 2000 | Robertsam
I had problembs with taping the signal to on the buzzer with machine tower light.However I try to connect parrallel to the light but the control board which connected to the light malfunction after 1/2 hour.The tower light is trigger by the ground s
Electronics Forum | Fri Oct 31 09:57:34 EDT 2008 | sys_steven
That's an amazing shot in the Dark. Never had to put in a CD to make it work....But, you could also try to add aluminum foil to the light tower to improve the reception, maybe that will help! Or even bring in someone to meditate over the machine wh
Electronics Forum | Tue Jan 03 07:47:44 EST 2023 | richardcargill
No electrical schematic sadly - and there is no sign of a connector under the mounting hole, so I'm guessing that it's never had this function. The actual light tower on it looks remarkably similar to a DEK printer one, so there's a chance that the
Electronics Forum | Mon Sep 28 10:51:02 EDT 2009 | shanenaturalpoint
My company recently purchased an MPM AP27 on the used market. I had the machine up and functional at one point, but now it is inoperable. I have correct power and air to the machine, but when I attempt to power it up, I get nothing. Red light on t
Electronics Forum | Tue Jul 06 12:25:54 EDT 2010 | isd_jwendell
I agree, setting a standard for the pcb fab shop is good. I use a fiducial a little smaller than the spec you mentioned, I use 30 instead of 40 mil, which is the minimum recommended for my machine. The rest of the spec (SMEMA Standard 3.1) appears th
