Electronics Forum | Wed Aug 31 13:02:36 EDT 2016 | cyber_wolf
Some of the MPM machines have a SMEMA configuration in the software. Not sure about the UP500.
Electronics Forum | Wed Aug 31 17:39:44 EDT 2016 | dekhead
2 on SMEMA end of cable) does it indicate downline available?
Electronics Forum | Wed Sep 07 07:53:16 EDT 2016 | ttheis
Looks like I've got to reconfigure the fmi connections. Only pins 1 & 2 populated and when I jump the fownline pins the upline ready signal is activated. I'll reference the diagram and setup the connections for smema.
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Fri Apr 21 16:55:16 EDT 2006 | Geo E
I am trying to find out if the AP20 MPM Printer is SMEMA ready or was it an Add-on, I can not find any documentation in the manual as to where the Smema is to be connected.Or does the diagrams show any smema hook ups. Any help would be appreciated.
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas
board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?
