Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Tue Oct 31 17:01:22 EST 2000 | Anders Benson
What defines the Cadillacs and BMW's of board handling equipment? This industry seems to meet conditions for being commodity, and it is difficult to differentiate one line from another. But talking to people, alot of the same names come up. My the
Electronics Forum | Mon Apr 11 13:11:30 EDT 2016 | gbkellyk
Hi, I hope someone is able help me I have just purchased a used ASYS LSB03 bare board loader and when I have switched the unit on the display reads MODUL 02 OFF also the control panel is frozen and does not respond to any of the buttons when pressed.
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
Electronics Forum | Tue Jan 03 08:17:53 EST 2006 | chunks
We have a conveyor then a FIFO in the middle and a conveyor and a Mag loader at the end. If your oven doesn't have SMEMA (like ours) then you need to the conveyor before each. We trick these conveyors by shorting out the in coming SMEMA so they con
Electronics Forum | Mon Jul 20 11:46:18 EDT 2009 | msherwood
I’m having trouble with the transfer of one board from the UIC conveyor to a DEk screen printer. They are set up for SMEMA to SMEMA but the DEK keeps asking for a aboard when it already has one. Then it will ask for one every 5-8 seconds. DO I have a
Electronics Forum | Mon May 06 10:50:11 EDT 2019 | youngbuck
Hi Kristof, I checked the tacho everything is ok with that, its reading a constant 0 -0 and belt tension looks good. Not sure what else to try. The smema problem is that it will not accept a board from the previous S20. Ive changed smema cables, s
Electronics Forum | Tue Mar 17 16:35:50 EDT 2009 | gregf912
Try switching pins 1 and 2 on the smema cable going to the CP6 machine. Fuji needs contact close then open to send/recieve boards.
