Electronics Forum | Thu Aug 25 06:57:41 EDT 2011 | SBecmpe
I just started with this company and the machine is being used for a different process. I am noticing small differences in the wiring that do not appear to be original. Ex. The SMEMA is missing. There are unmarked wires. Schematics would really set m
Electronics Forum | Tue Mar 29 13:14:28 EST 2005 | bobpan
Anyone familiar with making smema work on the ekra x5. I believe is was manufactured with a siemens (not smema)setup. We found the cables to make the siemens work but i am not sure if i can short a couple of inputs on the cable to make the smema func
Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
Electronics Forum | Thu Dec 03 14:40:27 EST 2015 | proceng1
When we had a line that ended at an older reflow oven without SMEMA controls, I ran a momentary switch to the two pins in the connector. I push the button and the conveyor pushed the board onto the edge-hold of the oven. As a joke I labelled it "LA
Electronics Forum | Sat Jan 17 07:25:18 EST 2004 | Andreas
I need to connect a Universal HSP (SMPI, Upstream) with a SMEMA interfact (downstream). Can anyone give me some information about the SMPI interface? Or does anyone have a schematic of a conversion box from SMPI to SMEMA? Thank you! B.R. Andreas
Electronics Forum | Sat Nov 07 22:00:29 EST 2015 | ttheis
I've seen a few used machinery companies using manual smema interface boxes with a few buttons on them to simulate upline and downline equipment but I haven't found anyone selling them or info on them. Does anyone know where they can be bought or if
Electronics Forum | Thu Sep 19 07:55:41 EDT 2002 | Claude_Couture
Dilbert, You are both right! Just above the schematic in the Smema standard it says: "Conformance to the standard may be achieved by the appropriate design of the equipment or by providing special adaptors which enable the equipment to meet the stand
Electronics Forum | Wed Sep 01 14:45:57 EDT 2010 | mmccance
Has anyone had any experience with SANSDA? We have a board loader that was bought used with no documentation. We have tried to contact them requesting schematics or a SMEMA manual to no avail. The loader is not completing the circuit telling the d
Electronics Forum | Tue Nov 03 22:11:38 EST 1998 | phillip hunter
| SMTnetters: | | My UIC conveyors aren't working with my: | | �Omniflow 7 Reflow (Mfg 1/95) | �Dek 265 GS | �Philips CSM | | | What can I do? Does anyone have experience with connecting UIC or other conveyors to the above equipment? On the refl
Electronics Forum | Wed Nov 04 18:13:53 EST 1998 | Michael Allen
I assume that you're dealing w/ Universal's SMPI connectors (and possibly their cables too). We've fabricated "conversion boxes" to accomplish what you're trying to do. These boxes have a female SMPI plug on one side, a female SMEMA plug on the opp
