Electronics Forum | Wed Sep 25 10:13:32 EDT 2002 | davef
I don't think 'this a blatant violation of rules' as such. I think it is a blantant disrespect of the principle of free and open communication that is the corner stone of interenet forums and a slap in the face of everyone that wants to learn more a
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Wed Apr 10 21:47:55 EDT 2024 | ddfreeze
have swapped 2 different boards, can try switching the dram sticks, or ordering new ones. also the cmos battery on the motrola communications battery was dead, put a new one in, was wondering if there was a cmos reset/ jumper?
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Sat Mar 24 00:08:55 EDT 2007 | mika
Fully SMPI (there are 2 kinds of SMPI and Universal used them both in the past). Converter cables between SMPI > Fully SMPI Converter cables between FUJI > Panasonic Converter cables between FUJI > SMEMA Converters between almost any machine interfac
Electronics Forum | Sun Jul 19 23:19:47 EDT 2015 | langkeauto2015
We are one of the leading manufacturer of high speed led pick and place machine from Shenzhen ,China, during the communication with our foreign clients, we found that, many USA clients want desktop pnp machine ,rather than high speed model, we are wo
