Electronics Forum | Wed Jul 12 16:17:33 EDT 2006 | nodlac
FYI Here is the SMEMA Link for the generic interface configuration. http://www.smema.org/smemastandards.htm and http://www.smema.org/smema1.2.pdf These Doc should give you the SMEMA pin outs. Cal
Electronics Forum | Wed Jan 21 11:02:41 EST 2004 | highfallsfunding
Hi Andreas. The SMPI is a proprietary Universal board transfer protocol. GSM platforms from about 1996 and newer have both SMEMA and SMPI. Although UIC later called it BPP1 (Board Pass Protocol) and BPP2, which is basically SMPI for lane-1 and SMP
Electronics Forum | Wed Nov 29 10:48:37 EST 2006 | bas Rottier
Hello, I'm looking for a protocol description of the SMPI interface (we would like to connect a SMPI machine to a SMEMA machine). Does anybody have description of signals (electrically) + waveforms + pin-layout + connectortype? THanks Regards bas.r
Electronics Forum | Mon Jul 20 22:07:21 EDT 2009 | mika
Hi, I just read your post. I think I know what's your problem is. In the DEK 265 (I assumed that is the model?)There is a special card for such things. For. ex. Fuji interface, Panasonic, Siemens, and UIC SMPI - interface. Uninerversal has therir own
Electronics Forum | Wed Apr 21 14:38:30 EDT 2010 | remullis
Newer Universal Conveyors use 4 wire smema and FUJI should accomodate this protocol in its config screens. Old Universal Conveyors and some machines used SMPI (forget how many wires), You can purchase the 4 wire smema cable from UIC and conversio
Electronics Forum | Tue Jan 08 17:46:38 EST 2008 | swag
If the phone jacks have two conductors in them, I would wire them to standard SMEMA connectors so that the upstream side goes to the middle two SMEMA pins and downstream goes to the outermost two pins. If there are 4 conductors in the phone jacks, y
Electronics Forum | Tue Dec 29 11:38:40 EST 2015 | g2garyg2
Hi Tom If the DYNAPACE has SMEMA out all you need to do is place a two wire jumper into pins 3&4 or 1&2 depending upon DYNAPACE's SMEMA configuration. This will by-pass a Release signal and feed PCBs into the oven.
Electronics Forum | Tue Sep 20 15:00:26 EDT 2016 | awhite
Got it!!!!! On the main Operator Screen for the MPM UP2000, and under configuration (when logged-in under maintenance), it gives you ONLY the settings that the machine is set to....there are no drop-downs or options available to choose from. Very fr
Electronics Forum | Thu Jul 23 09:30:22 EDT 2009 | dekhead
It isn't clear if it was working and stopped, or if this is the first time you've tried to make it work. If this is first try, need to confirm cards and cables on DEK, and what interface is configured on UIC. I have SMEMA cards in stock if needed. P
Electronics Forum | Tue Nov 03 22:11:38 EST 1998 | phillip hunter
| SMTnetters: | | My UIC conveyors aren't working with my: | | �Omniflow 7 Reflow (Mfg 1/95) | �Dek 265 GS | �Philips CSM | | | What can I do? Does anyone have experience with connecting UIC or other conveyors to the above equipment? On the refl
winsouce.jpg)
